|
I am replacing my 6 Volt 1600 engine in my Dune Buggy. The new engine is 12 Volt and I have verified the 12 Volt flywheel teeth count. I obtained a supposed 12 Volt starter to use with the new engine. My problem is I'm not sure how to tell if the starter...
Started by bbuggy on
, 11 posts
by 8 people.
Answer Snippets (Read the full thread at thesamba):
IF you run a 12 volt starter in a 6 volt transmission, you will alsoIf you do have a 6 volt starter it will work in a 12 volt system and will also match up to the 12....
power of the newer, bigger engines.
|
|
I am installing a 50 ford dash in my model a roadster, and want to use the inst out of the 50, what do I do for a voltage drop? do I use a voltadrop on each inst, and what sending unit?
Started by 48fordnut on
, 20 posts
by 14 people.
Answer Snippets (Read the full thread at jalopyjournal):
Jim ford used 6 volt gauges up until 71 or....
I would assume a 12v bulb would burn dimmer when only If not you'll still have to use the original senders for Fuel, Temp and Oil Pressure .
In the line from the power source to the gages.
|
|
7.3 volt power source for an SD2200d. CostasDee on Sat Apr 02, 2011 7:20 pm
Hi guys (& gals),
Got a 12v to 7.3v regulator on the SD machine, but the 12v batteries are quite heavy. Looked at the Coiltek Li-Ion Regulated System, but the cost is about $4...
Answer Snippets (Read the full thread at 4umer):
CostasDee Contributor Plus....
Granite2 on Sat Apr 02, 2011 7:48 pm
Hi Costesdee
If your than half the big one, and a lot less than the original 6 volt battery that came with the SD.
Re: 7.3 volt power source for an SD2200d.
|
Ask your Facebook Friends
|
I just purchased a 6 volt battery from tractor supply for my cub. I decided to fully charge battery before installing. I have had it on an automatic charger for 3 days,it has charged to close to 75% but will not go to 100% charge. Is this normal for a...
Started by vanceboroguy on
, 12 posts
by 10 people.
Answer Snippets (Read the full thread at farmallcub):
Don't buy the batery is, 6 volt batteries have a tendency to sit around longer than 12 volt batteries do the correct size ....
If you ar buying a 6 volt or a 12 volt battery, the same things apply when buying.
|
|
I have just "repaired" my cd player. It came with a an internal transformer which switched either 120v ac or 240v ac to 9 volt dc internally. (I imagine it is 9 volts DC because it also will take 6 1.5v C batteries at the back) I was using it in a room...
Started by bardos on
, 16 posts
by 10 people.
Answer Snippets (Read the full thread at straightdope):
It also....
(measured 6.5v on my multimeter) One other regulator).
I guess I'll go with the 6 volt DC transformer...
Or DC.
|
|
Thought I'd post this one since we get a lot of questions on it, here's a cheap 6 volt reducer.
I don't like those resistors (they get too hot) and I've tried those expensive voltage drops (fried em')
How about a cell phone charger! I found this at an...
Started by Rocket88 on
, 17 posts
by 16 people.
Answer Snippets (Read the full thread at jalopyjournal):
And you can test componants like power windows, radios and such with out running a wire clear on the phone charger...the LM78xx series has been around for decades, but the switching power supply.
|
|
Volt as Emergency Power Generator I am writing this posting from my cell phone while sitting in the driver's sear of my Volt. Relax, the car is on but parked in my garage.
We were avacuated from the Outer Banks on Thursday, and drove back to Philly. When...
Started by Slapshot28 on
, 7 posts
by 5 people.
Answer Snippets (Read the full thread at gm-volt):
It returned about 16 hours later (most of my service is underground), yet we still have many other towns... .
Uprooted two small trees in my backyard that were replanted later), left the island around 6:30 AM west electrical power immediately.
|
|
I thought I scored when I found that local parts houses carry this reducer.
I thought I would have to order one or build one( I saw the thread on here)
....But when I hooked it up to run my gas gauge, I checked the output side and it was still reading...
Started by 54cruzer on
, 14 posts
by 8 people.
Answer Snippets (Read the full thread at jalopyjournal):
On whether 12 volts will burn up a 6 volt motor, some have run them for years on 12 volts, I guess the amps rating on my fan???
There is controversy on whether 12 volts will burn up a 6 volt motor at that....
|
|
I was fortunate enough to be the guinea pig for Jim Franzens new LED bulbs for 6 volt single filament cars. I just got these today and stuck them in the car in 5 minutes and let me tell you, these things are incredible! Honestly, the pics don't do them...
Started by Wiggy on
, 20 posts
by 11 people.
Answer Snippets (Read the full thread at thesamba):
As they are so compact I can see them being able to be used across a whole range of vintage 6 volt machinery...VW and others.
|
|
5 Volt 20Amp power supplies on Ebay Hi, I not know these sellers - found these 2 items whilst looking for PSUs for my display.
A lot of amps for your $.
I am in the UK so the postage makes them expencive for me.
http://www.ebay.co.uk/itm/Mean-Well-......
Started by Barnabybear on
, 4 posts
by 3 people.
Answer Snippets (Read the full thread at doityourselfchristmas):
Re: 5 Volt 20Amp power supplies on Ebay Originally Posted by Barnabybear Hi, I not know 20Amp power supplies on Ebay Anyone have a line on a beefy 12 volt version?? I'm thinking I need a bit more horsepower for my Rainbow Floods....
|
