|
Im trying to get my sc400 emission tested on the dyno but he said he cant turn the TRAC control off? is there a way i can turn it off with out the button because the button does not work? iv heard that you could possibly remove the TRAC relays is that...
Started by sc101 on
, 6 posts
by 2 people.
Answer Snippets (Read the full thread at clublexus):
Doesn't the sub-TPS control TRAC? This is the specifications for your to adjust on our cars? and do you know what the abs means as well? thanks again.
It sounds like two issues.
|
|
Wanting to get 275-40r17 front and 275-40r18 rear for a slightly aggressive stance, but I'm afraid since the r18 tire is ~1" wider in diameter (and thusly the tires will rotate at different speeds) that this might trigger the 'low trac' light and cause...
Started by justinmc978 on
, 20 posts
by 6 people.
Answer Snippets (Read the full thread at ls1tech):
4.11 Gears ABS/Low Traction issues.
It's not the width that will cause issues, it's the 1" difference in height that causes ABS issues 3.90 S-Trac |
1982 Corvette (SOLD!!)
LS1, T-56, MONSTER lvl 3 clutch with 18lb flywheel.
|
|
Just got my 97 xk8 on the road after some v5 issues, when I bought it it had the abs and trac light on, so while waiting for the dvla I refine the solder joints, removed and cleaned the sensors, charged the battery , replaced all brake pads and fully ...
Started by ferrarikid on
, 11 posts
by 4 people.
Answer Snippets (Read the full thread at jaguarforum):
The easy way to fix cars is always get the fault codes read , clear the faut codes , and drive car and read codes again... .
Sounds like a wheel sensor connection or faulty sensor as i would think it can only be this due to the disc rotating the opposite way .
|
Ask your Facebook Friends
|
I replaced my hub bearing after getting the TC-Code and my abs and trac lights are still on?? what could it be??
Started by frankief on
, 5 posts
by 4 people.
Answer Snippets (Read the full thread at cadillacforums):
The code stays in the PCM until....
There's your problem.
Clear it and see what happens.
Did you plug the connector back in when finished? Did you clear the DTC's or drive it 3 times after the install? I did plug it in but i havent cleared or driven it yet .
|
|
Anyone had the same issue? ive checked fuses but all seem ok?just came on on the way home from work today? any ideas?
Started by mhill53 on
, 12 posts
by 7 people.
Answer Snippets (Read the full thread at volvot5):
As above dry solder joints on the abs ecu, if your still working fine where abouts is ....
Normally,in volvotech of salisburys words,nearly always the ecu on the abs pump,had mine fixed if your unit needs fixing,about 50 i was charged....
|
|
I am going down this weekend to look at an 03 tenth ann. cobra with an SRA. Dealership says that the abs and trac light are on because of the sra swap. Any ideas why this is and can it be fixed? I haved searched the forum but haven't found anything so...
Started by sanfordb1 on
, 6 posts
by 6 people.
Answer Snippets (Read the full thread at svtperformance):
Yes....
Hell maybe they deleted the ABS block all together.
Either way it is no big deal.
So take a look and see.
My guess is they just unplugged the old sensors and never put any ABS components back on (exciter rings or ABS sensors).
|
|
My wife's 02 Grand Prix has been activating the ABS on very low speed (parking lot) turns, where the ABS kicks in and the ABS light comes on with the Trac light. I took to our local garage and they "honed" ( I believe) the sensors in the hubs, test drove...
Started by No Tyme on
, 5 posts
by 4 people.
Answer Snippets (Read the full thread at pontiacforum):
GMs are well known for....
And they said they test drove the car and the ABS light came on, the Trac lite also came on and the infotry a different shop or a GM dealer that can scan ABS systems Well I spoke with them today experencing.
|
|
Okay heres the scoop while leaving the movies in my 01 lexus is300 my ball joint snapped causing my wheel to go completely sideways. After replacing the balljoint i still had lights. I made sure the abs sensor is in flush and ive tried resetting the ecu...
Started by slammedis300it on
, 4 posts
by 3 people.
Answer Snippets (Read the full thread at my):
abs sensor seeing its the same motor and specs?.
|
|
Recently I have had my VSC TRAC & ABS lights flashing upong starting my 4Runner. This originally started after I removed the battery in order to change the upper marker light buld un the headlight housing. This was happening when I started the Runner ...
Started by BReardon21 on
, 5 posts
by 3 people.
Answer Snippets (Read the full thread at toyota-4runner):
To the thread:
One cause & fix for "VSC TRAC" & "VSC OFF" lights, Zero Point Calibration
I did this today.
|
|
Yes, yes, I know this question has been asked in different forms, but I did the search and it seems there are a few different answers with different symptoms, so I wanted to see if maybe somebody can offer their two cents on this situation.
Here's what...
Started by CT300 on
, 9 posts
by 4 people.
Answer Snippets (Read the full thread at my):
As for the rotors....
My fix for the trac off light.
I had the same prob a few days ago . .
ABS light and flashing TRAC OFF light
BTW and reset the speed/wheel/abs sensors.
The post with attachments at the top of the thread below .
|
