Omgili - forum search, search forums  
  

Discussions about diy engine oil

Displaying 1 - 10 out of 1,906 discussions.  
Time Frame: (Any time)   Minimum number of replies: (2)   Minimum number of discussing users: (0)
  |  

Page: 1   2   3   4   5   6   7   8   9   10  
Keep this page open to be updated with the newest discussions automatically.
Tech section in this forum has specs and fluid amounts for you're engine, just search you.
Quarts.
I added legs so it sits in the "channel" in the fenders. See pics. The legs are made of 3/4" thick wood. Because the hood slopes down, one end of the leg has to be 4.75" long, the other, 4.25" long. Note that the legs "toe in" to follow the fenders so...
Started by on , 25 posts by 10 people.  
Haha!!! i was thinking....
Those are structurally rated.
Home Depot carries Simpson hangers and braces.
So I made my own engine brace and the entire engine load sits on the top fenders a normal engine brace...
Rack, and oil pan...
I posted this in the Periodic Maintenance Section. See you there. DIY: 2007 Ody LX Engine Oil Change made sweet and simple! Nothing new, but browsing the forum, I see no DIY for 3rd Generation Engine Oil Change so I decided to write a short and sweet ...
Started by on , 1 posts by 1 people.  
Answer Snippets (Read the full thread at odyclub):
Ask your Facebook Friends
DIY: 2007 Ody LX Engine Oil Change made sweet and simple! Nothing new, but browsing the forum, I see no DIY for 3rd Generation Engine Oil Change so I decided to write a short and sweet DIY for Oil Change using wood ramps and no need to jack the car up...
Started by on , 2 posts by 1 people.  
Answer Snippets (Read the full thread at odyclub):
Do NOT remove the Engine....
Slightly open the Engine Oil FILLER Cap a few turns to allow air to enter the engine.
To mix up the oil and any contaminants (remember the engine is still warm from the previous trip.
DIY: 2007 Ody LX Engine Oil Change made sweet and simple! Nothing new, but browsing the forum, I see no DIY for 3rd Generation Engine Oil Change so I decided to write a short and sweet DIY for Oil Change using wood ramps and no need to jack the car up...
Started by on , 2 posts by 1 people.  
Answer Snippets (Read the full thread at odyclub):
Do NOT ....
Slightly open the Engine Oil FILLER Cap a few turns to allow air to enter the engine.
To mix up the oil and any contaminants (remember the engine is still warm from the previous trip faces the drain bolt.
DIY: 2007 Ody LX Engine Oil Change made sweet and simple! Nothing new, but browsing the forum, I see no DIY for 3rd Generation Engine Oil Change so I decided to write a short and sweet DIY for Oil Change using wood ramps and no need to jack the car up...
Started by on , 2 posts by 1 people.  
Answer Snippets (Read the full thread at odyclub):
Do NOT ....
Slightly open the Engine Oil FILLER Cap a few turns to allow air to enter the engine.
To mix up the oil and any contaminants (remember the engine is still warm from the previous trip faces the drain bolt.
Will the DIY engine oil change void the warranty? Shall I use synthetic oil for longer mileage instead of just 8,000km interval?
Started by on , 10 posts by 9 people.  
The cost is more and they still say i get 15,000 miles on... .
Engine Oil : Mobil 1 5W20 Oil Filter : Mobil 1 filter (usually included with oil deal) Use the soda bottle trick mentioned previously and hand tighten it on. Fill it the Oil Filter first? No! It's not a Diesel engine. You just poured 4.5 quarts into your...
Started by on , 2 posts by 2 people.  
Answer Snippets (Read the full thread at odyclub):
You may also need to add some rubber at the bottom to keep from sliding back when using it inside the garage with smooth... .
There was a link in the body of the message to take you for dimensions that I used .
Originally Posted by Noypi05 check tread #76 too.
DIY Oil & Filter Change i was bored...very bored. tech's @ velozt.com my STi is for sale
Started by on , 13 posts by 11 people.  
Answer Snippets (Read the full thread at clubwrx):
I don't....
Suspension and brake parts are different between STi and WRX a jack with a Subaru .
Tech's @ velozt.com anything on the engine will be the same.
Re: DIY Oil & Filter Change Originally posted by TRM i was bored...very bored.
Related Videos:
1. Whats the point of using torque wrench? 2. Which brand oil filter should i buy? 3. This is my first DIY oil change, what can possibly go wrong?
Started by on , 18 posts by 15 people.  
Answer Snippets (Read the full thread at camaro5):
Drain plug warranty problems....
This is my first DIY oil change, what can possibly go wrong? 1.
This is my first DIY oil change, what can possibly go wrong filter should i buy? 3.
Which brand oil filter should i buy? 3.
Page: 1   2   3   4   5   6   7   8   9   10  

Related Message Boards & Forums

  • 1992 - 1999 M3 (E36) - Bimmer The Ultimate BMW
  • RWD 19xx-1984 DeVille and Fleetwood 1985-1996 Fleetwood and Brougham
  • Mechanical Maintenance: Break-in / Oil & Fluids / Servicing - Camaro5 Chevy Camaro / Camaro ZL1...
  • Maintenance service and repair
  • Periodic Maintenance
More Information


Forum Search About Omgili Help Plugins Forum/Board Owners Privacy

i
In Title
In Topic
In Reply
Exclude
Boost