Discussions about fox rp23

Anyone install Fox RP23 Shim/Volume Spacer on Mojo? Has anyone played with either Fox shims or homemade ones (like DG's from Turner's forum)? I found myself using up a lot of the low/middle part of the travel on my SLR, so I thought about shimming it. Maybe the small sized one and lower the air pressure... Started by Cable0guy on Thursday, February 09, 2012, 17 posts by 8 people.   Read the full thread at mtbr Discuss this with your friends on Facebook Answer Snippets (Read the full thread at mtbr): Search using "shim" or RP23.... Search using "shim" or RP23, etc. Check out DG's write up in the Turner forum.

Repalcing Fox RP23 Du bushings with out special tools Hello, I am looking at replacing my du bushings in my Fox RP23 with the Enduro needle bearing kits. Has anyone taken the du bushings and installed the new needle bearing kits WITHOUT using the special tools from RWC? Just trying to save some $$$. Any ... Started by IRONMAN1518 on Saturday, January 28, 2012, 5 posts by 5 people.   Read the full thread at mtbr Discuss this with your friends on Facebook Answer Snippets (Read the full thread at mtbr): I used a 10mm socket,17mm socket and a vise,you will hear from other people that this is sketchy and you might mess your shock up and the world might flip on its axis if you dont use the proper tools.The socket and vise method works just fine.On another... .

RP23 boostvalve pressure tuning options RP23 bv has been out for a while now, but I haven't seen anybody post anything about fine tuning the boostvalve pressure. Can anybody with the right nitrogen gear adjust the boostvalve / Ifp pressure? What sort of results can I expect? What are the high... Started by joshdurston on Saturday, September 24, 2011, 25 posts by 10 people.   Read the full thread at mtbr Discuss this with your friends on Facebook Answer Snippets (Read the full thread at mtbr): The Anthem X specific RP23 BV has an "L" rebound tune, "F" compression tune offered for the RP23 was an AM version where the ProPedal damping adjustments are converted to pure moved on to a Monarch Plus.... Previous non BV Fox shocks.

Fox Float RP23 Boost - loss of rebound and propedal Yesterday I rebuilt my Fox Float RP23 Boostvalve shock on my RIP9. It went flawlessly and took 15 minutes. I did this because I was starting to see oil leaking out of the bottom of the shock - not a ton of oil, but it seemed time for a rebuild. I've done... Started by Jisch on Sunday, January 15, 2012, 6 posts by 4 people.   Read the full thread at mtbr Discuss this with your friends on Facebook Answer Snippets (Read the full thread at mtbr): I had similar issues on RPL which were resolved with changing oil in damper, performed by Fox. The oil. Agreed. Send it to PUSH/Fox/Suspension Experts. They are not user serviceable.

RP23 Recplacement on SJ Continued So I went in to my LBS the other day to see if they would be able to order the 7.5"i2i and 1.75" stroke length RP23 that comes off of the Cannondale Rush as a replacement for the Triad II. The manager, though he said he would order it if I really wanted... Started by half_man_half_scab on Monday, March 19, 2007, 25 posts by 11 people.   Read the full thread at mtbr Discuss this with your friends on Facebook Answer Snippets (Read the full thread at mtbr): I have.... I still have it if anyone needs one. I had a Fox Float R off a Cannondale Rush on my FSR XC Pro and it was way better than the Triad. The trail feel is absolutely incredible as bob there. Produces less travel and sag in the RP23.

Wanted:- Fox RP23- 200mm Following this thread:- http://www.retrobike.co.uk/forum/viewtopic.php?t=113543&postdays=0&postorder=asc&start=0 I am after a replacement shock for my 00 Sub 5. I believe some of you sell a few of these... Started by mph999 on Tuesday, February 14, 2012, 4 posts by 2 people.   Read the full thread at retrobike Discuss this with your friends on Facebook Answer Snippets (Read the full thread at retrobike): If you want to try the RP23 on mine - you're welcome to give it a go before you? I put an RP23 on my Orange MrXC.... What stroke do you need? I put an RP23 on my Orange MrXC - the predecessor of the 5 - and liked the difference it made.

Nomad C RP23 setup questions I just picked up a new carbon nomad and Im looking for some setup tips as its not feeling great just yet. What Ive found so far: Preload: I initially had this set to light, sounds like it should be set to aprox 2% under body weight not the 10% I had originally... Started by Soxx on Friday, February 10, 2012, 12 posts by 6 people.   Read the full thread at mtbr Discuss this with your friends on Facebook Answer Snippets (Read the full thread at mtbr): There's technically four adjustments on your.... When I'm looking. Unfortunately fox way is "full open"? I have a pre-kashima RP23 that came on my 2011 Blur LT. Was a bump of about 20psi and backed off the compression dampening all the way .

RS Pearl 3.3 gegen Fox RP23 tauschen Hallo, kann mir jemand beantworten welche Buchsen, Lager, Bolzen (?) etc. ich beim Austausch des Dämpfers eines Nerve ES 7.0 2007 benötige? Der Fox RP23 in 190/50,8 sollte ja passen, oder? Danke für die Info, richie Started by richie0815 on Friday, February 10, 2012, 4 posts by 3 people.   Read the full thread at mtb-news Discuss this with your friends on Facebook Answer Snippets (Read the full thread at mtb-news): Ich bin .... EBL und Hub passt! Buchsen sind 22x8 Ist dein Pearl hinüber oder warum der Tausch? Zitat: Zitat von CycloB EBL und Hub passt! Buchsen sind 22x8 Ist dein Pearl hinüber oder warum der Tausch? Danke für die Info! Ne, der Pearl funktioniert noch .

RP23 or DHX Air for my Delirium? Now that I have just built ma DH bike, I'm planning on converting my Delirium to an AM machine. I know it isn't exactly a trail/Am bike but I've loved it so much being my ONE bike that I'm keeping it as my AM bike. I'm currently running an RC4 with a ... Started by john85D on Friday, December 16, 2011, 10 posts by 8 people.   Read the full thread at mtbr Discuss this with your friends on Facebook Answer Snippets (Read the full thread at mtbr): Hi John, I would never have even chimed in on this thread had I not just managed to tune my RP23 for my Chilcotin.... Is in the first post...although the rest is interesting) DW 5 Spot RP23 mod You can also buy the fox than an RP23.

Help the new guy out..what RP23 settings do you use and when do you engage propedal? OK I'm new at the blur LT and full suspension thing here and I had a few questions about what some of you guys have found to work on your bikes. First a little about me and the trails i ride 1. bike = BLT2 with RP23 rear 2. i'm 5 foot 10 at 170 lbs wet... Started by gexas on Sunday, January 01, 2012, 14 posts by 10 people.   Read the full thread at mtbr Discuss this with your friends on Facebook Answer Snippets (Read the full thread at mtbr): I sent my shock into fox a few months back ride in an effort to make all .... Rebound is 4 clicks from slow. Anything more and it's harsh. I should be running instead of the 25 percent???? what are your other settings on the rp23? hi gexas.