|
Not sure if anyone will be able to help out but I though I'd try
Basically I'm after the location of the relay on the above vehicle(s) and a wiring diagram. Particularly on the TDi variants. Working on something to aid the guys in draining them as they...
Started by Darth Loo-knee on
, 5 posts
by 3 people.
Answer Snippets (Read the full thread at omegaowners):
But no relay info for either Audi or VW,presuming you want to use the in tank lift pump to empty tank but no relay info for either Audi or VW,presuming you want to use the in tank lift pump to empty tankJust checked Autodata....
|
|
I have had a slight starting issue for a while now...the fuel pressure at start-up wasn't holding so I have had to run the fuel pump twice before starting. Turning the key to the on position runs the pump for 2 seconds, then a switch to off and then to...
Started by CTSV_510 on
, 20 posts
by 12 people.
Answer Snippets (Read the full thread at ls1tech):
It goes from am 18awg something....
Hot wire kit is basically running a new fuel pump wire and adding a relay and using the old fuel pump wire to trigger the relay.
I think an f-body kit might do the trick.
|
|
Went to start up my jeep this sat to take it to the bank
has been sitting since the weekend befor when i went wheelin
cranks, when i turn the key no fuel pump
poped the cover on the relay box
took a jumper wire and jumped 30 and 87 on the relay socket...
Started by ryan86jeep on
, 17 posts
by 5 people.
Answer Snippets (Read the full thread at jeepsunlimited):
The pump is controlled by some other device and likely the pressure should....
Abreviate please? Auto Shut Down relay, Fuel Pump relay so the auto shut down can control the ground is on the hot side of the relay.
|
Ask your Facebook Friends
|
When I turn the key on the fuel pump does not prime. They by passed the relay and put voltage straight to the pump and the pump started. I'm being told I need a new computer. The tank has been off several times in the last few months and the starter switch...
Started by BossHawg on
, 15 posts
by 10 people.
Answer Snippets (Read the full thread at vtxcafe):
I had two fuel....
If the fuse is good, replace the relay for little over 1 year.
Make was bypassed and the pump works, check the fuse.
The 1800 cannot.
Do you have a 1300 or 1800? I believe the 1300 fuel pump can be bypassed.
|
|
Someone posted that you can use the relay that controls the fuel pump (or starter, I think they are switchable?) to crank the engine from under the hood. Can someone assist me in finding that link. How did you take the reply apart so that you can squeeze...
Started by tgrudzin on
, 12 posts
by 6 people.
Answer Snippets (Read the full thread at neons):
Can also pull plug from coil if spark of the... .
Can also pull plug to the cylinders, pull the fuel pump relay while testing.
If you don't want fuel to the cylinders, pull the fuel pump relay while testing.
|
|
VW GOLF MK3 GTi 2.0L 8V '94 (Engine code 2E)
I always work better with pictures so figured someone might find this post useful.
Step 1: Position the car on a level surface
Step 2: Depressurize the fuel system
You can do this by either leaving the car ...
Started by freezaburn on
, 8 posts
by 7 people.
Answer Snippets (Read the full thread at golfgtiforum):
Good right up! What a write up, nice one mate I need... .
The bottom of the fuel pump has a strainer which is kept only a few millimeters with the bottom of the tank and thus will not be able to efficiently pump fuel.
It in place.
|
|
So i have a 98 2 door 4x4 blazer. The front u-joint on the rear drive shaft finally went out so i i replaced it. after getting the drive shaft put back in i went to start it and the fuel pump didn't kick on. So i began that great adventure, Haven't replaced...
Started by thebandnerd03 on
, 6 posts
by 3 people.
Answer Snippets (Read the full thread at gm-trucks):
trick and got the fuel pump to kick back on and i have good pressure (yeah i know needs to be replaced 2011 - 04:19 PM, said:
ok so i did the old pound on the tank trick and got the fuel pump to kick back, but....
|
|
Hello All,
I have a 50 trim SRT-4 with a PTP fuel pump rewire kit. The install only uses the SSR (solid state relay) to control. I have a walboro 255 installed. On the freeway last night my fuel cut out all together. This is the first time this has happened...
Started by 50trimRyan on
, 4 posts
by 4 people.
Answer Snippets (Read the full thread at srtforums):
Now I just control my fuel pump.
I mounted it by the steering wheel, it looks trick.
In an inline switch.
|
|
As soon as I turn my key into the on position the fuel pump kicks on and won't shut off. Is this a problem, has anyone else had this issue? 2004 Switch I with the MP 350.
Started by Utemachine on
, 6 posts
by 4 people.
Answer Snippets (Read the full thread at tigeowners):
I have a 2002 Merc and a few years ago my fuel pump would start running the second I turned tap with your....
I have a 2002 Merc and a few years ago my fuel pump would start running be the relay.
Might be the relay.
|
|
So, my old '87 B2 suddenly won't start. It was parked and not ran for a week or 2, which normally isn't a problem except now it won't start. If you spray starting fluid into it, it'll start then stall. When the key is turned on, I don't hear any fuel ...
Started by pattygook on
, 6 posts
by 3 people.
Answer Snippets (Read the full thread at broncozone):
The Yellow wire on the fuel pump relay....
From there it goes to the inertia switch and then to the fuel pump on the Fuel pump relay to pick it.
Supplies power to the Fuel Pump relay.
|
