|
As far as I've been able to tell, whenever you override an audio route in the iPhone, you have to change both the output AND input routes together. The only available routes I'm aware of are:
"Headset" "Headphone" "Speaker" "SpeakerAndMicrophone" "HeadphonesAndMicrophone...
Started by alexbw on
, 3 posts
by 3 people.
Answer Snippets (Read the full thread at stackoverflow):
I'm going to try to instantiate two audio units, one for playing, the other for acquisition, but I'm... .
After talking with Apple engineers on the Coreaudio mailing list, I've found it's not currently possible to do this with a single RemoteIO audio unit .
|
|
Hey Guys, So far, in the 2 years or so of having my 11 rack i havent had a single issue. I haven't needed to use the headphone output until now, and it appears there may be a problem.
I'm connecting the headphone out to an old receiver and speaker system...
Started by Hotcrazyfruit on
, 3 posts
by 3 people.
Answer Snippets (Read the full thread at avid):
Be muted.
|
|
All,
I am currently using 2 different guitars, routing one to Out1, and the second to Out2. However, when I listen in the headphones on the Axe, I only hear from guitar #1.
Is it possible to have the headphones output to be used as another routable block...
Started by SLM on
, 2 posts
by 2 people.
Answer Snippets (Read the full thread at fractalaudio):
|
Ask your Facebook Friends
|
I'm using the digital out to my computer to feed my pioneer receiver, which sadly doesn't have normal outs for the signal. So to use it as a DAC for my Sansui 9090 I plugged a cable into the headphone jack of the Pioneer and fed it to the Main RCA inputs...
Started by jindra on
, 13 posts
by 7 people.
Answer Snippets (Read the full thread at audiokarma):
On an old surround amp that didnt have a sub output I ran from the headphoneSorry, but you are using the Pioneer....
I've done it.
You really don't want more than one volume control in the loop, and headphone output # 5.
To say the least.
|
|
Hello!
I bought a TV with no headphone jack and I read online I could use an adaptor from RCA input (red and white sockets).
I bought a twin phone lead, connected it to two-phono to 3.5mm stereo adaptor, and finally to a 3.5 stereo coupler.
unfortunately...
Started by loucat on
, 3 posts
by 3 people.
Answer Snippets (Read the full thread at hexus):
If your TV has multiple scart sockets you might find that one of ... .
You'd probably have to mess with something inside the TV to rewire the output to the RCA sockets...
If the RCA is an input then I doubt it will also function as an output.
|
|
Apparently, users are not allowed to use active speakers on LCD TV via the headphone output...
Just discussed with an engineer that a TV whose' headphone output has failed isnt covered by warranty when it was used with Active speakers (in this case, Audio...
Started by Marcos on
, 3 posts
by 2 people.
Answer Snippets (Read the full thread at avforums):
So in fact, a powered speaker thing that the circuitry... .
The only means that they would put less of a load on the TV headphone output.
There is no issue with running a headphone output into powered speakers.
An AE engineer.
|
|
Just discussed with an engineer that a TV whose' headphone output has failed isnt covered by warranty when it was used with Active speakers (in this case, Audio Engine A2)
I'd like your advice/input?
How can laptops be completely fine with having active...
Started by Marcos on
, 11 posts
by 6 people.
Answer Snippets (Read the full thread at hexus):
But sounds like the output impedance of the TV....
How old where these TV's?
I can't imagine the impedance of say a wireless headphone basestation to find the output impedance of the TV and the input impedance of the active speakers...
|
|
Just discussed with an engineer that a TV whose' headphone output has failed isnt covered by warranty when it was used with Active speakers (in this case, Audio Engine A2)
I'd like your advice/input?
How can laptops be completely fine with having active...
Started by Marcos on
, 11 posts
by 6 people.
Answer Snippets (Read the full thread at hexus):
But sounds like the output impedance of the TV....
How old where these TV's?
I can't imagine the impedance of say a wireless headphone basestation to find the output impedance of the TV and the input impedance of the active speakers...
|
|
Hi guys!
I have a Scarlett 2i2 and im a bit in chock over how low the max volume is on the headphone output! Its driving my Shure 840 headphones and they arent very difficult to run..
I just ordered a Saffire PRO 24DSP, and im returning the Scarlett.
...
Started by Bass on
, 7 posts
by 6 people.
Answer Snippets (Read the full thread at gearslutz):
output impedance is? I'm looking to maybe purchase one but I'd like to know more about the headphone volume is on the headphone output! Its driving my Shure 840 headphones and they arent very difficult output....
|
|
Just discussed with an engineer that a TV whose' headphone output has failed isnt covered by warranty when it was used with Active speakers (in this case, Audio Engine A2)
I'd like your advice/input?
How can laptops be completely fine with having active...
Started by Marcos on
, 3 posts
by 3 people.
Answer Snippets (Read the full thread at hexus):
But sounds like.
How old where these TV's?
I can't imagine the impedance of say a wireless headphone basestation to find the output impedance of the TV and the input impedance of the active speakers...
|
