|
Posted 06 January 2012 - 03:23 AM So received some new speakers and was going to install them in the doors, however while i'm at it I decided to purchase some sound deadening material to install while I had the door trims off.
Went to my local jaycar...
Started by karma_syke on
, 4 posts
by 2 people.
Answer Snippets (Read the full thread at skylinesaustralia):
And dont use jaycar tar based imitations without knowing they tend to fall off? If its on a horizontal surface can i use a less extreme glue? something that i could peel off.
Nonslip mat.
|
|
Thought I'd list my current activity here for interest. This is a low priority project but one that I am sure others can comment on and provide guidance.
I have a solar inverter that has a RS232 serial port that I can extract information about the output...
Started by brett on
, 15 posts
by 3 people.
Answer Snippets (Read the full thread at dangerousprototypes):
Personally I have zero suitable drills, so a trip to Jaycar here in AU will give me a 1mm drill that I am for a Wiz812MJ ethernet module....
Suitable drills, so a trip to Jaycar here in AU will give me a 1mm drill that I am sure I can manage.
|
|
On Tue, 17 Jun 2008 12:14:17 +1200, "~misfit~" <misfit61nz@hooya.com.au
S'probably just electioneering but I hear they banned them across the ditch
a few years back too.
"It is intended that from late next year, these inefficient incandescent ...
Started by ~misfit~ on
, 14 posts
by 5 people.
Answer Snippets (Read the full thread at omgili):
Jaycar also have some
lamps....
I've been peeling
onions for pickling in the evening of late, had to replace one;rnickel@RemoveThis-actrix.co.nz
Jaycar have a good range.Wellington branch has them set up to the light.
To be desired.
|
Ask your Facebook Friends
|
I have a B&D firestorm 18V cordless drill that works great but the charger decided to die, i've tested the output and there is 0 voltage (should be 21.75V 210ma ) i'll put an ad in the buy/sell section but what are my chances of finding a powerpack that...
Started by loanrangiel on
, 20 posts
by 9 people.
Answer Snippets (Read the full thread at austech):
I'll check the fuse Reschs, and if that is all good I'll visit Jaycar.
Thanks all.
Carefully peel back the tape covering the winding near batteries will do it.
Circuit ?
If so the thermal fuse has gone.
|
|
Everything old is new again :)
So my son for his 18th wanted a turntable. Yep, a good old fashioned vinyl spinner. “No”, says I, I already have one! Out of the store room and off to an electronics shop went the first and only turntable I ever purchased...
Started by Mac Dude on
, 20 posts
by 9 people.
Answer Snippets (Read the full thread at atomicmpc):
The one I'm thinking of is rubber based and does not bond to vinyl .
Ended getting a Project Debut, very no frills simple piece of kit but the engineering it to try and peel it off.
They sell at Jaycar.
|
