|
Cant Find Short In 5a "run" Circuit, Keep Blowing Fuses
I have a short in my 5A run circuit that pops fuses instantly. It seems to be a bad short. My audio wiring hasn't been hacked up at all and I have not modified the harness in any way. The RUN circuit...
Started by The_Ghost on
, 14 posts
by 9 people.
Answer Snippets (Read the full thread at tccoa):
5a run fuse, behind the dash does....
Short? Today I was driving around and all of a sudden my blower motor kicks on high speed .
A short in ANY of these will blow the 5A RUN fuse.
They are all Purple / Orange.
Of these wires ..
|
|
Which fuse box/ which fuse are the tail lights? the ones that are always on at night, not the brake ones. both of mine went out, so I'm suspecting a fuse..
Started by Zoni on
, 5 posts
by 4 people.
Answer Snippets (Read the full thread at 8thcivic):
Once one of the tailight the blinker/hazzard ....
It was because of just crappy bulbs on those :P stupidpig ur badass that clears up one fuse whats of the fuse, as all of them driving by the same fuse 15 under your dash panel.
|
|
I was trying to disable my fuel pump the other day so i removed the fuse under the dash and to my surprise the fuel pump was still cycling with the key. THEN i replaced the fuse and noticed that when the fuse is in place the fuel pump just runs Constantly...
Started by overboost7845 on
, 1 posts
by 1 people.
Answer Snippets (Read the full thread at preludepower):
|
Ask your Facebook Friends
|
So I was mowing a rather rough section of my property a week ago, looking for the outlet to my septic system that is stopped up. My front wheels fell into a rut and before I could kill the blades, they dug into the ground. Mower stopped and won't start...
Started by OGJordan on
, 10 posts
by 5 people.
Answer Snippets (Read the full thread at mytractorforum):
If the PTO has a direct short ....
Mine was just a nick in the insulation but was enuff to blow fuse.
Tell me, does the tractor operate fine the wire, or some such .
For sure! Yeah, just run-down the circuit with a multi-meter.
|
|
Went for a ride yesterday to a friends house, and upon leaving, he asked about my added running lights below my fairing if they stayed on all the time. They're driving lights from advance auto parts, and I have them hard wired into my headlight circuit...
Started by crimson_tide on
, 4 posts
by 3 people.
Answer Snippets (Read the full thread at vtxcafe):
If you choose to run like....
You need to run the lights off.
Then use can safely use the headlamp circuit as the trigger for the relay, so that functionality will remain the same .
Of the many fuse box mods that you'll find online here.
|
|
Posted 06 March 2012 - 02:10 PM
Ok guys on my fjr 1300 2003 which i think we are not to many left.I have a problem that cant figure it out .I need some help from the Gurus.This is what happening. run the bike for few days and the running light fuse gets...
Started by staintune007 on
, 7 posts
by 5 people.
Answer Snippets (Read the full thread at fjrforum):
I put a cruise control on my bike when I got it and ... .
You make any changes to the bike shortly before the first fuse popped? If so, reexamine what you did - 05:50 PM
A bad tap can increase current draw, too, just by being a little flaky.
|
|
Hi, this ones got me totally confused!!
Took my car for a quick spin around the block today to bed in new brakes etc as it's MOT is booked for saturday. Everything was fine for around 1/2 mile then the engine started running really roughly and was miss...
Started by Rusty and proud on
, 10 posts
by 3 people.
Answer Snippets (Read the full thread at volkszone):
I couldn't see how it would effect the engine....
Http://www.vintagebus.com wire going into the Main loom to the rear should be on the same side of the fuse as the Blk wire.
The car should start and run even with all of the fuses removed.
|
|
A little intro... All my lights worked before i performed a desmog. During the process i replaced the alternator, fusible link, and heady duty battery cables. My problem is that my fuse to the dash/running/tail lights keeps blowing. I have no front marker...
Started by 88bj73 on
, 5 posts
by 2 people.
Answer Snippets (Read the full thread at ih8mud):
New question though, do you ....
So i took out the whole connector so now its just the female(?) end exposed it.
I just went out to look at them they looked like the plastic connector had just went to dust and left two wires exposed.
|
|
I've searched the cherokee forum but to no avail. and I'm wondering on my brothers 94 Jeep Cherokee i'm replacing fuses on the panel under the dash and the little tabs that the fuses plug into have either been pushed through or something. curious as to...
Started by Jeepman659 on
, 7 posts
by 3 people.
Answer Snippets (Read the full thread at cherokeeforum):
Not all of the fuse positions are used, the unused ones have no clips, or sometimes just the "power? If that didn't work, I'd probably just bypass the fuse box and do an in-line fuse with new wiring in front of the tail....
|
|
I lost electrical power to the bridge fuse block that runs the accessories like radar, gps and vhf. All other 12v accessories not associated with that block, such as the blowers and nav lights still work as they are another fuse block elsewhere. Nothing...
Started by Boat28 on
, 18 posts
by 14 people.
Answer Snippets (Read the full thread at boatered):
The bridge accessories breaker powers installed fuse....
Sometimes corrosion builds up installed fuse block on the helm...they just didn't do that.
run it down and check connections from the fuse block back to the batt.
|
