|
I'm thinking about giving my rhino a paint job, but I can't decide whether to go with the Krylon Fusion Hammered Black, or the Krylon Fusion Textured Black. Does anyone have any experience with these two paints, and know what one is more durable and will...
Started by Tyler2262 on
, 15 posts
by 9 people.
Answer Snippets (Read the full thread at rhinoforums):
I was impressed....
A Krylon Fusion paint job on my Rhino and i like the decals but have seriously considered leaving them off I remember that the Fusion instructions on the can said to clean with an ammonia based cleaner and rinse story.
|
|
Ok I want to paint my tank, and even have the krylon fusion. Problem is its not gonna get up to 50F any time soon highest its gonna be is 38 tomorrow, And theres no way I can spray paint inside. So I'm wondering if I can do it in the garage with a space...
Started by Zari on
, 5 posts
by 3 people.
Answer Snippets (Read the full thread at monsterfishkeepers):
I dunno, sounds like krylon and a space heater can other paint by krylon, Dual....
Leaving only the garage.
I have used krylon in my garage to paint block them from that room.
Just spray your krylon paint and see what happens.
|
|
Does krylon make a good match for klr olive green? I have recently purchased a olive green stock klr 650 and some of the plastics are quite bad. I would like to prep and paint some but not all of the plastics. My problem is that I would like them to ...
Started by Michiganman33 on
, 4 posts
by 3 people.
Answer Snippets (Read the full thread at klr650):
I did tape off the decals to keep the stock look Re: Does krylon make a good....
Re: Does krylon make a good match for klr olive green?
Pull a panel and head to Home Depot a KRylon red that was close and amm satisfied with the finish.
|
Ask your Facebook Friends
|
Hi, my name is Tania and I am from Rio de Janeiro - Brazil
I bought a brand new Ford Fusion 2008 on 13 January 2009, but I was not able to drive it properly since I bought it.
After getting out of Ford dealer shop Barrafor in Rio de Janeiro and driving...
Started by Tania Bolerio on
, 30 posts
by 12 people.
Answer Snippets (Read the full thread at smallvolvos):
While I understand your concern, I don't see anything in those - Brazil
I bought a brand new Ford Fusion 2008 on 13 January 2009, but I was not able to drive, I would suggest to have a close look below....
If they used the krylon fusion.
|
|
Build Your Own "Vortex Fusion" Chiller #1 serialc0d3 Vampire Join Date Sep 2008 Location Harrisburg, PA Posts 33 Build Your Own "Vortex Fusion" Chiller – 09-23-2008, 05:57 PM Tweet
Lets build a chiller that follows the same design principles as the Vortex...
Started by serialc0d3 on
, 10 posts
by 6 people.
Answer Snippets (Read the full thread at halloweenforum):
If this....
That stuff hardens like steel.
You want around an 1inch:
I used Epoxy Putty to hold the pipes into place .
Serialc0d3 Vampire Join Date Sep 2008 Location Harrisburg, PA Posts 33 09-23-2008, 06:01 PM Check the gap of the output pipe to the lid .
|
|
I'm thinking about painting my grills and louvers with Krylon Fusion paint gloss black. Has anyone done it? Please post pix if you have.
Started by Eliseeyoulater on
, 12 posts
by 8 people.
Answer Snippets (Read the full thread at lotustalk):
Turned out.
I used Krylon Fuzion Paint for plastics.
With the type of plastic the parts are made with .
|
|
On Sun, 28 Jun 2009 10:06:49 -0400, Mike Walsh <spam_sucks@bellsouth.net
The reverse gear on my 2006 Ford Fusion 5 speed manual transmission will not engage. This happened after a problem occurred while parallel parking. I had the transmission ...
Started by Mike Walsh on
, 34 posts
by 10 people.
Answer Snippets (Read the full thread at omgili):
In Canada the 06
fusion has a 5 year/100,000 km powertrain warranty - one would assume! I matched the color and sprayed....
Is the 2006
Fusion manual transmission made in another country? 2008/2009 Focus 5 speed
manual Information Guide....
|
|
Can you paint a blank any color? I noticed in mud puddle catalog they have "blank paint". What if I don't wanted it the be a primary color? They said it was "Fusion" but I know that is Krylon.
Started by b>Wolf on
, 4 posts
by 3 people.
Answer Snippets (Read the full thread at rodbuildingforum):
Krylon Fusion works like.
Mike Yep.
They changed it to Universal? Go crazy with whatever color you want .
|
|
Buddy of mine put on a tube bumper so I got his factory bumper (cause it was straight!) and replaced my bent one. Fender flares painted with Krylon Fusion, cashed in on another buddy to buff it out and DROVE IT!
Started by wmsthree on
, 6 posts
by 6 people.
Answer Snippets (Read the full thread at jeepforum):
Up automotive primer and Krylon Fusion for plastic to paint the jugs (I try too hard lol)
Primed.
|
|
Well everyone is starting to figure out how tight i am so, heres another project. Used some 1/2 pvc pipe i had laying around, a screw, and black tape. Even shot a coat of Krylon fusion on it.
Started by 29va on
, 7 posts
by 4 people.
Answer Snippets (Read the full thread at va-huntfish):
Me and my buddies waitin....
Hey that will work Not being tight just using your brain Thats were all these fancy ones come from NRA Life Time Member Whatever works out for ya! Ain't no place that I'd rather be than with a bunch of y'all rednecks just like me .
|
