Omgili - forum search, search forums  
  

Discussions about speedo gear

Displaying 1 - 10 out of 3,921 discussions.  
RSS Feed Options
Time Frame: (Any time)   Minimum number of replies: (2)   Minimum number of discussing users: (0)
  |  

Page: 1   2   3   4   5   6   7   8   9   10  
Keep this page open to be updated with the newest discussions automatically.
Hi All, Are there multiple speedo gears available for an 1997 DOHC AT? Will 215/45/17 tires fit on a Neon? I have a set of 17x7 +35 wheels that I would like to put 215/45/17 tires on (stock height). It would be nice to have a little more ride comfort ...
Started by on , 17 posts by 5 people.  
Answer Snippets (Read the full thread at neons):
:) those rims determine which speedo gear I have? Thanks! Pull it out and look at the color.
I recall reading several warnings about dropping the speedo gear in the trans.
Calculations.
So my 91 has the electronic speedometer and I would like to swap gears. My problem is besides buying an expensive Dakota box do I have any other options? I thought I read somewhere that you can change out the reluctor ring to recalibrate the signal to...
Started by on , 21 posts by 6 people.  
Go back and read the sticky threads about speedo gears and review the site James linked this on ebay......
The VSS has a driven gear.
It has a drive gear just like a car with mechanical speedo.
Ring on the output shaft.
Hi people, I am new to the "New" Ford Truck list, but was a member of the "old" list back in 1997(?). Since then I have had a heart attack, am recovering, AND have changed the rear end gears in my '79 F-150 (2wd). Went from a 2L75 to a 3L25 and my annual...
Started by on , 14 posts by 4 people.  
I've have put bigger tires on it and have changed the gear to correct the speedo speedo gear that you replaced? (Right hand pitch gear) //// //// //// (Left hand pitch gear) \\\\ \\\\ \\\\ And....
With that trans.
Ask your Facebook Friends
Is there a speedo gear available for the T5 to suit 3.9 Gears? Has the US boys with Stangs got a speedo gear to suit our Aussie T5? Ford Aus has only upto 3.45 :( Can you get one in as I am unsure of the exact one i require
Started by on , 4 posts by 3 people.  
I've just used the electronic speedo corrector.
To be honest with you, I haven't looked into it .
So i am getting a vino soon! and am going to have a stage6 street race bbk on it and put a dellorto 17.5 carb on it then obviously gears and variator and the tranny works. my question is, the vino50 speedo only goes up to 40mph or so would it work to ...
Started by on , 14 posts by 4 people.  
Inchers, if i used the speedo gear from the 125 would it work? they are basicallly the same size, style pro handlebars, ncy handlebar mount, acewell 1500 speedo, 84 main jet, needle from an '05 carb are wrong anyway, I bet a 1....
Is the speedo gear clip suppose to have the open end toward the cable or away from it? It clips on either way.
Started by on , 6 posts by 3 people.  
Registers fine when I put a drill on the Dana ... .
The auto type gear it doesAlso curious as my speedo hasnt worked ever since I put the new cable in.
Probably doesn't matter on the manual (or D20, left pic) type speedo gear.
Okay, I will admit that math was never my strong suit. I mean I can barely add, and trying to figure out effect of tire size and gearing changes on speedometer readout is KILLING me. Here's where I start: an '83 60 speedometer assumes stock 235/75R15 ...
Started by on , 14 posts by 13 people.  
Answer Snippets (Read the full thread at ih8mud):
The speedo is very close just off a little shop and they will make you a correction....
HID's, OME , Trail-Gear Sliders, Rear Lock-Right, 33x10.5 BFG A/T's on 15x8 Eagle 058's I have that exact setup - after abt 55MPH add 3pmh to compensate.
Im in need of new speedo drive gears in my gearbox, its a 1900 box and will be using 15" wheels, i currently have the red drive gear in there but my speedo over reads by about 10mph does any one know which 2 gears i need thanks
Started by on , 4 posts by 3 people.  
Strangely I've just got back from taking the engine out of my car and splitting the box, also to change the speedo cog's have a red pinion and a white cog on the diff....
Pretty sure you need the black cyclinder cog thing and black drive gear.
Have a 98 zj in process of lifting and putting 31 inch tires! What sire gear tooth do I need to go to for recalibrating speedo?
Started by on , 5 posts by 4 people.  
Answer Snippets (Read the full thread at jeepz):
Just trying to be preparedHere's an web address....
If I go with the 305s will that really make a difference? I would have to go to a 40 speedo gear to do it by the chart.
That measure 33.8" I already have a 41 speedo gear for 33s.
Quaife LSD missing speedo ring/gear? Does anyone know if the Quaife LSD comes with the speedo ring/ gear? I have purchased one second hand and someone has pointed out that this is missing? Can they not be taken from the standard diff and put into the ...
Started by on , 5 posts by 2 people.  
Got to love it when people make comments like.
The speedo ring will be taken from the standard diff.
"Hatton" Type R.
Standard.
TRO>CTRO.
The diff missing the speedo ring gear for an ep3!"...
Page: 1   2   3   4   5   6   7   8   9   10  

Related Message Boards & Forums

  • Bronco Tech - ClassicBroncos.com
  • XU Engine & Gearbox Service and Maintenance - 205GTIDrivers
  • 60-Series Wagons
  • www.neons.org • 1st Gen
  • Streetbuilt Racing - Australian Ford
More Information


Forum Search About Omgili Help Plugins Forum/Board Owners Privacy

i
In Title
In Topic
In Reply
Exclude
Boost