|
Okay, the caps I replaced because of buldging/puffiness:
2 x 1000uF 16v by the inverters
1 x 330uF 25v
4 x 820uF 25v
The caps I didn't replace which weren't bulged/puffed up:
1 x 10uf 50v
1 x 47uf 50v
1 x 100uf 16v
1 x 100uf 450v
I know that caps that...
Started by nickt1862 on
, 16 posts
by 3 people.
Answer Snippets (Read the full thread at badcaps):
Have proper DC voltage to the inverter section, then you could have a blown fuse and/or shorted out mosfets/transistors in the inverter section.
|
|
Hey guys.
i am planning to buy an inverter for home. but confused as to which ope to buy as there are a number of brands in the market. i need your suggestions and help in choosing the inverter and the inverter battery. i have had good experiences with...
Started by sriharsha on
, 12 posts
by 8 people.
Answer Snippets (Read the full thread at theautomotiveindia):
I ....
Mods may please "DELETE" the thread instead of closing it as there in no info to be run when there is a power cut .
Turn off all other loads and can use it too on 800 VAinverter purchased.
To use mixer for urgent use, which my mom do .
|
|
I'm looking for the least expensive way to monitor my house bank battery levels while out in the boat!
I have a Xantrex Freedom Marine 25 inverter on my boat that handles power/charges my house bank. I see there is a phone jack plug on the front of the...
Started by Boat28 on
, 14 posts
by 9 people.
Answer Snippets (Read the full thread at boatered):
I use a Link2000 remote monitor on my Xantrex 2500 off my house Battery Status & ....
Also or battery bank is with a digital volt meter .
It for granted that you do have
a good GPS) It depends many people at anchor turn off their GPS.
|
Ask your Facebook Friends
|
Hello all.
I removed the 1997 audiovox crt 12" tv from my boat this winter as it stopped working. I would like to put in a 26" LCD mounted to a hinge bracket that can be stowed and tied when underway.
I could go with one of the more expensive Jenson DC...
Started by Boat28 on
, 12 posts
by 9 people.
Answer Snippets (Read the full thread at boatered):
62.5 A times 10 ( battery voltage, minus inverter on if the inverter is ext or internal....
Divide" to avoid over-discharge/battery stress.
A times 10 ( battery voltage, minus inverter and other system losses ) = 625 watts of storage.
|
|
Ill try and keep it short.
Basically Im trying to run my Makita dropsaw off the van battery.
I used the power meter to test the wattage of the saw off the house mains, for about 2 seconds it runs at 1450watts then once its up to speed it drops down to...
Started by KennyM on
, 13 posts
by 10 people.
Answer Snippets (Read the full thread at geekzone):
Motor starting current is up to 6 times the rated current... .
Your inverter is rated for 2kW peak load but a 255mm Makita is a 1650kW motor.
You've got pretty much no show running a drop saw with a domestic inverter off a van battery.
|
|
My screen keeps turning off if i play with the brightness the screen will come back on i think this is a inverter problem were can i get a inverter for a white plastic macbook and how do i fix it thanks in advance
Started by maxlf079 on
, 2 posts
by 2 people.
Answer Snippets (Read the full thread at apple):
Http://www.ifixit.com/Guide/Installing-MacBook-Core-Duo-Inverter-Cable/4766/1#.T.
In case I've linked the wrong model, be sure to use the ID your mac bit of the site .
The inverter cable itself.
|
|
Hi All i have a Baier LCD tv and the screen keeps turning on and off it has two input boards, one with scart sockets and other one is with VGA and it happen with both inputs i dont know if it is the inverter board or power board could some kindly guide...
Started by maz on
, 20 posts
by 3 people.
Answer Snippets (Read the full thread at badcaps):
If the screen is not lit (and....
All the caps look goodIf you have the TV on in a dark room, does the screen still glow when it goes off? Thanks Tom.
Then is did not go off.
On main board where wires are going to the inverter board.
|
|
Coworker's HP L1955 let out a thin stream of acrid smoke and stopped working the other day. Pulled the Benq 48.L1A02.A00 inverter board (at least I assume that's what it is from reading other posts on this truly educational forum). One of the surface ...
Started by eastcoastjoe on
, 14 posts
by 7 people.
Answer Snippets (Read the full thread at badcaps):
If it burn't up then most likely one of the C5707s shorted and for some reason... .
The SMT chip is the backlight on/off MOSFET.
Toast
Sounds like Yesterday I just found a guy selling the OEM Benq inverter transformers (part there's a source.
|
|
This is my first post here, i need help on my final year project to make a grid connected inverter.
For the full bridge inverter circuit i planned to use IRF2807 (75V Vds, 82A Ids) and Two IR2110 for the driver. I never use IR2110 before and failed many...
Started by adityo.kusumo on
, 15 posts
by 5 people.
Answer Snippets (Read the full thread at edaboard):
Here are the schematic for the test circuit :
it goes well when i push on-off the Hin.
|
|
First post after following badcaps for awhile, so let's get right to the heart of the issue!
Model : LG30-UA
Issue : Worked fine one night before going to bed. When I woke up in the morning it didn't.
Symptoms :When I turn it on it briefly displays the...
Started by Austin420 on
, 20 posts
by 7 people.
Answer Snippets (Read the full thread at badcaps):
You can unplug and remove the slave inverter and the tv will still turn and have then youll need to post a picture....
You can unplug and remove the slave inverter and the tv will still turn and have the 2 seconds shorted mosfets.
|
