Omgili - forum search, search forums  
  

Discussions about wear sensors

Displaying 1 - 10 out of 4,853 discussions.  
Time Frame: (Any time)   Minimum number of replies: (2)   Minimum number of discussing users: (0)
  |  

Page: 1   2   3   4   5   6   7   8   9   10  
Keep this page open to be updated with the newest discussions automatically.
Just been doing some reading about brakes. Even though mine will be no where near doing, I just wondered if there was a wear sensor on the mk2 Leon? Will it only show brake pad wear, or does it show disk wear as well?
Started by on , 12 posts by 5 people.  
Hmm: : My Cupra doesn't have the....
My Cupra doesn't have the wear sensors.
I think the warning comes up on the MFD these Not all do - I forget what the criteria is though .
The brake pads do have a wear sensor but not the discs.
Anyone know what the current TC price is for these?
Started by on , 11 posts by 7 people.  
And a wear sensor last week from my local stealers....it come to less than £ 30....but it started at £ 50Pads 9192124 £26.35 £22.40 £15.00 Sensors 90495144 £10.60 £9.55 £8.00 Many thanks much appreciated on again today are the ....
Do I need the wear sensors fitted? I changed the discs and pads yesterday and the sensors light is now on and flashing. If I unplug and remove them will the dash light stay on or off? I have no need for it as I check my brakes regularly.
Started by on , 2 posts by 2 people.  
You can leave them out and the light will be off. .
Ask your Facebook Friends
I have read old posts on this subject but have not found the answer Should the sensors be fitted after the caliper has been closed or before.
Started by on , 2 posts by 2 people.  
It's easiest.
Not found the answer Should the sensors be fitted after the caliper has been closed or before.
I bought these for my 2007 335xi but never needed them and I have sold the car. Asking $35 for both front and rear sensors. Located in Cambridge
Started by on , 6 posts by 3 people.  
Answer Snippets (Read the full thread at e90post):
Thanks for the info....well yours are only $....
They fit on all e9x non M series.
I'm sure you can call the dealer to find out .
I dont remember if these will also work for a 325/328....any idea? if they will, I'll take these To be honest, I have no idea .
Hi, I have a 2000 W163 2.7 tdi and my brake wear indicator has come on, but only flashes occasionally. I will probably do job myself but can you tell me if there is a sensor per caliper, i.e totalling 4 needed or is there just 1 at front and 1 at rear...
Started by on , 2 posts by 2 people.  
sensors, sadly the 163 is not on my list.
Seal Grey 996 C4S MY03 Previous: Ocean blue 986 Boxster S MY01(Yep owned the same 1 twice!) Audi TT 225 MY01 Ocean blue 986 Boxster S MY01 Last edited by davidarose on Mon May 14, 2012 10:15 pm; edited 1 time in total Gibbo205 Master Joined: 27 Dec 20...
Started by on , 1 posts by 1 people.  
Answer Snippets (Read the full thread at 911uk):
I tried my hardest to get that bulb to go out legitimately... give the car the respect it deserves an all that. anyway after replacing both sensors and rewiring the rear brakes, still no joy.... so then i tried shorting out the entire circuit at the back...
Started by on , 15 posts by 3 people.  
If theres a break in the circuit, ie when the wear sensor is....
If the sensors connection gets broken from wear, the sensor is then "open", thus closing the special switch the circuit to the wear sensors.
The RB IKitesurf Sensor is dead and after corresponding with the Ikitesurf guys it is likely not coming back unless they can find a new home for the equipment. If anyone has a contact, I know they would appreciate it. While we are at it, maybe there are...
Started by on , 9 posts by 5 people.  
Answer Snippets (Read the full thread at pskite):
Its just upwind of jetty island....
But when you buy a $10 broom stick and you wear $75 board shorts you can combine the two to make in a professionally managed sensor? Bueller? How about Jetty, GG, RB, DB? Or even Hunter or Dogfish at jetty.
Anyone have a cross-reference for just the wear sensor, without replacing the factory pads?
Started by on , 3 posts by 2 people.  
Page: 1   2   3   4   5   6   7   8   9   10  

Related Message Boards & Forums

  • Suspension Steering & Brakes - Mercedes-Benz Owners'
  • General Mercedes-Benz Related Discussion - Mercedes-Benz Owners'
  • Puget Sound Kiteboarding Association - Pacific Northwest Seattle Tacoma Bellingham and surrounding...
  • 911uk.com - Porsche Specialist Insurance Car For Sale Finance Parts & Service : Porsche Car...
  • Tech Help - :: E30owners.com :: Irelands BMW E30 website
More Information


Forum Search About Omgili Help Plugins Forum/Board Owners Privacy

i
In Title
In Topic
In Reply
Exclude
Boost