|
Hi, I have a question regarding the way you park the cars.Will there be any effect on the steering system of the car ,(i mean the modern cars with all those fundu power steering stuff) in case I park my car with wheels aligned in any other direction other...
Started by joecherian on
, 15 posts
by 12 people.
Answer Snippets (Read the full thread at team-bhp):
In case I park my car with wheels aligned in any other direction other than being straight of the driven wheels are more or less the same while the inner wheel has to move a lot lesser while will be under stress if the ....
|
|
I changed the timing belt and stuff this summer and from undoing the motor mounts my engine shifted towards the drivers side. I've had a vibration since then and I couldn't figure it out so I changed the ball joints and tie rods (it needed done anyway...
Started by aguitarmn on
, 25 posts
by 7 people.
Answer Snippets (Read the full thread at neons):
There is a procedure to align the engine mounts, but it involves measuring and adjusting the engine axle? Put it in the air and spin....
The two motor mounts on the passenger side and then put a jack between the tranny and wheel and pushed.
|
|
First off, I realize that my own situation is not nearly as serious as most posting here. Nevetheless, I am asking for help.
I'm 37 years old, male, and very fit. I had recently taken up roller skating (it's called "quad skating" now) and almost immediately...
Started by ElSquinto on
, 20 posts
by 5 people.
Answer Snippets (Read the full thread at kneeguru):
Outward while my wheels point straight ahead - clever, huh?) - but I suspect my saga isn't over yet.
|
Ask your Facebook Friends
|
One of my favorite and most memorable moments in Grand Theft Auto IV was speeding down the airport runway at night in my sports car with Ray Lynch's "The Oh of Pleasure" on blast. Going full speed towards the bright runway lights, which grew larger and...
Started by MrOogieBoogie on
, 50 posts
by 48 people.
Answer Snippets (Read the full thread at neogaf):
Completely summed up.
The bike drops onto two wheels and I zoom off.
As the motorbike comes to halt on its front wheel only Blondie sings the word "Atomic".
As I landed pulled an endo.
To Blondie - Atomic.
|
|
Hey guys,
Not sure if I'm posting in the right section, so mods feel free to move. Here's my issue:
My car's alignment was fine until i switched from stock 2006 LX hubcap wheels to 2007 SI rims. I put brand new tires on all four rims (Federal tires). ...
Started by UG7890 on
, 19 posts
by 6 people.
Answer Snippets (Read the full thread at 8thcivic):
The tires werent purchased from them so they didnt really have a reason to mess around with tire/wheel words, can i do this myself tomorrow....
Pulling.
Easy question first: High speed vibration- misbalanced wheels tires or a bent wheel.
|
|
Hello , I'm trying to add a top menu with the module " prestaloveeasymenu " but I can not set it on the top left at all.
I have checkes the css code where I found "float: left" but there is something that are blocking the menu to set to the left at all...
Started by ill7 on
, 7 posts
by 4 people.
Answer Snippets (Read the full thread at prestashop):
Do you know if I can write a specific code .
Of the menu-bar starting from the wheels of the cart.
|
|
I took the S202 for an alignment as the tyre wear was uneven and ride quality poor. They didn't complete the alignment because:
- The nearside (front left) wheel is 2-5 cm further forward that it should be..!
- There is a shuddering when steering at low...
Started by tim.mcd on
, 15 posts
by 5 people.
Answer Snippets (Read the full thread at mbclub):
And is the steering wheel aligned OK in the straight ahead driving - if not how is it ?
Steering wheel is straight....
And is the steering wheel aligned OK in the straight ahead driving.
Pattern is on each wheel.
|
|
A few weeks ago a customer brought us his GLI for suspension work. It started as a completely stock appearing car and left with quite a different attitude. We installed coilovers, aligned the car and fitted 19" RH RAN replicas with Dunlop tires using ...
Started by TTWforrest on
, 4 posts
by 3 people.
Answer Snippets (Read the full thread at dallasimports):
Thanks for the kind words!
We did for a wheel guy to make
AJ- ....
Also, the wheels are actually RH RAN replicas.
Also, the wheels are actually RH RAN for the awesome service.
Thanks again for the awesome service.
To everyone I know.
|
|
Hi peeps
Have just ordered myself a set of Eibach 30mm springs, will i need to get my wheels re-aligned once they are fitted?
Steve
Started by Steve_184 on
, 14 posts
by 8 people.
Answer Snippets (Read the full thread at corsa-c):
Didn't do mine, although alot of people say you should i would say no tbh mine seem fine and im down by 40mm atm but when i got my coil overs fitted im definately getting mine checked to see if they need doing, my mate in his corsa d went through brand... .
|
|
2nd Gen Mazdaspeed 3 Wheels I purchased new daily wheels and am selling the 2nd gen wheels that came with my car. I can honestly say that these wheels are absolutely flawless with one EXTREMELY tiny exception on one. They look brand new and both of my...
Started by fishdonotbounce on
, 15 posts
by 7 people.
Answer Snippets (Read the full thread at mazdas247):
I love how these look on a Gen1 Speed3 although][RKM Shifter base bushings][Eibach Pro Kit Springs][18'' Kyowa Racing wheels][Hankook V-12 tires][35%Tint] Can get a nice set of NEW lighter ....
Oh I wish my current wheels would sell already.
|
