|
My problem is I tinker when there's no need to...
My Pacifica 112 is a pre-update model. The 112V released a couple of years ago (and most of the other letters in the range) has a coil tap on its bridge humbucker, and I'm jealous. Does anyone know if ...
Started by imalone on
, 13 posts
by 2 people.
Answer Snippets (Read the full thread at guitarnoise):
An actual coil tap involves "tapping" into the wire coil at some point late in the coil, so you can effectively have that) is what color wire ....
Coil option? The two terms kind of got blended together at some point, strange .
|
|
The camera has three leads: video (yellow), 12v red and ground black.
Pioneer x920 headunit.
Idea is to hook up yellow to video in obviously, but I need to know where the best and cleanest taps are for 12v, ground and switchable video from the headunit...
Started by tvmaster on
, 28 posts
by 10 people.
Answer Snippets (Read the full thread at mazdaspeeders):
Ignore the dots.
|
|
What is called a tap that is connected to the house wiring to provide hot water? Is it called "electric tap"?
Started by Geneva Conventions on
, 4 posts
by 4 people.
Answer Snippets (Read the full thread at yahoo):
Instant hot water dispenser or boiling water tap an electric water heater single point electric.
|
Ask your Facebook Friends
|
I know you can use 1 of the fuel injector wires. (Anyone know exactly which 1?)
What other wires can I tap into to get an RPM signal? (For window switch)
It's a 3.8
Started by LocoLT1 on
, 3 posts
by 3 people.
Answer Snippets (Read the full thread at hyundaiperformance):
You can tap into the ground wire.
Not going to be able to get a signal from that .
tap into the ground wire of any coil though I would think.
|
|
Where do I tap a wire for the remote wire to power on my amp.. I've tried every wire that connects to the Harmon kardon amp in the back.. And the white wire everyone is saying to ap doesn't work.. Can someone plz help me!?!? Oh and it's a 2000 323i
Answer Snippets (Read the full thread at e46fanatics):
Let me know if you find.
Ive got the same problem dude...that white wire is not the remote wire...
|
|
A 220V hot water tap was connected to a 127V wiring? This question is from my book. This table, shown there, brings all the tap's data:
http://www.flickr.com/photos/76342179@N0…
The question says that a 220V-model one was connected to a 127V wiring and...
Started by Giulia on
, 4 posts
by 4 people.
Answer Snippets (Read the full thread at yahoo):
Which is correct....
But at hot 220 volts, there are two power numbers, 4500 and 5500 watts .
So there are two different models and the 220 volt one is connected to 127 volts?
Assuming that the resistance does not change with temperature (probably false).. .
|
|
If a modem router has been compromised - is there a way to observe the traffic out of the modem onto the internet. Wireshark can observe traffic inside the LAN but I'm looking for some sort of wire tap to observe internet traffic out.
Can a computer be...
Started by SparTacux on
, 3 posts
by 2 people.
Answer Snippets (Read the full thread at ubuntuforums):
I presume it can be wire tapped with the right equipment?.
|
|
A post for our 'E39 M5 FAQ'... I'll detail the specific wires to tap into for the install of each bit. I noticed that EAS doesn't list the Video Source Module on its site anymore, but this info could be expanded to any similar unit. I just finally wired...
Started by TorqueDog on
, 9 posts
by 6 people.
Answer Snippets (Read the full thread at m5board):
It is for a dynavin....
Did you ever figure out which wire to tap into? I am installing my reverse camera on this? I was looking to tap a trigger wire up near the front of the car if at all possible.
Which wire that is.
|
|
I haven't seen this answered elsewhere.
What is the proper way to tap into a 12VDC wire on my boat?
My C-25 has one lead for cabin lights that goes to all of them; I'd like to tap into it and wire up 2 more. I can't see a way to do it that isn't an invitation...
Started by CarbonSink62 on
, 10 posts
by 8 people.
Answer Snippets (Read the full thread at sailnet):
Strip about 1.5 inches of insulation from....
I've used hot glue have relatively good access to the area, strip about 1-inch of the insulation from the main wire.
As suggested you could put something in the two wire side to seal it.
In the 14.
|
|
Anybody know how the taps switch on the throttle lever is wired? Just installed new actuator for taps wake plate on lencos word it was bad cause it would only go in and not out and still have same issue. If I swap the wires white to white black to black...
Started by topaz surfer on
, 1 posts
by 1 people.
Answer Snippets (Read the full thread at tigeowners):
|
