|
As well as my Accord throwing out an engine code (P0135) I think I also need a new Distributor.
I know sometimes you can just replace the O-Ring, but I am not sure if that was the issue. You can see from the pictures that it was really brittle.
It looks...
Started by mgold on
, 19 posts
by 6 people.
Answer Snippets (Read the full thread at garagejournal):
I think the o-ring could fix the problem.
I was planning on replacing it! BTW, it is a 1996 Honda Accord.
|
|
Got a CEL last week. P0135 (Driver's side front sensor). I was going to order the sensors via Amazon. There are two part numbers:
234-4169 (Front specific, OE replacement)
234-4209 (Universal front)
Not much price difference between the two (~$10?). What...
Started by cackalak han on
, 11 posts
by 6 people.
Answer Snippets (Read the full thread at ih8mud):
Rockauto also lists the 4169's
2000 TOYOTA LAND CRUISER Oxygen Sensor
2000 UZJ100 | DT Headers | 295/70R18 NTG | Tundra 18" | OME T-Bars | 866 Springs | Slee Diff-Drop | Soon: TJM T13 [2011 Style] | BIOR Rear I'm wondering if the 4169 has the correct ... .
|
|
This is a follow-up to an earlier post, the nature of the problem has changed a bit and since it's been about a month since the last post, thought I'd start over.
Trying to get a 96 FSB to get through emissions testing so I can sell it. First time I took...
Started by biederboat on
, 20 posts
by 4 people.
Answer Snippets (Read the full thread at fullsizebronco):
DTC P0135
During testing the HO2S Heaters are checked for opens/shorts and excessive current draw P0135, P0141, P0155 AND P0161: HO2S HEATER SIGNAL CIRCUIT IS OPEN, SHORTED TO GROUND, SHORTED TO B+ OR EXCESSIVE CURRENT DRAW; Possible Causes....
|
Ask your Facebook Friends
|
On Sat, 6 Jun 2009 08:21:42 -0500, "lobo" <el_lobo@nowhere.net
Can't seem to get rid of this code as it keeps reappearing and have replaced
the bank 1sensor . I have been trying to find what voltage readings I should
have on the vehicle side plug...
Started by lobo on
, 4 posts
by 3 people.
Answer Snippets (Read the full thread at omgili):
After chasing down all the wires,
which were.
& 4 and just
could not keep from throwing a CEL P0135.
|
|
Hi.
When I fill my water reservoir to the maximum level, the water level drops to the minimum level over a 4 week period, car has travelled 1,000 miles during that time. Does this sound about right to you?
Car is a 2006 with 20,000 on the clock. No smoke...
Started by Deadmanwalking on
, 18 posts
by 11 people.
Answer Snippets (Read the full thread at mr2roc):
(o2 sensor heater malfunction (bank ski , will try to help!)
These... .
P0135 drivers side position.
(o2 sensor heater malfunction (bank 1 sensor 1)
P0141 code your get with cheap 02 sensors .
P0135 drivers side position.
With cheap 02 sensors.
|
|
New to Forum
I've a 2001 4X4 Tundra with 25000 miles, check engine light came on, I disconnected the battery overnight, light was off for about 15 minutes of driving the next day then came on again. Steeler wants $75 to run a scan, anybody else have same...
Started by ronaldnnn on
, 15 posts
by 11 people.
Answer Snippets (Read the full thread at automotiveforums):
As for the o2 sensors, the most common codes are p0135 and p0155 bank 1 sensor 1 and bank 2 sensor 1 o2.
|
|
Does anyone know what may cause a SES code regarding bank 1 sensor 2 lean. Simple as replacing the sensor? Truck seems to run fine with 84000 on it. By the way it has the 5.3 w/fuel management.
Started by dcoperator on
, 8 posts
by 4 people.
Answer Snippets (Read the full thread at chevroletforum):
P0121, P0122, P0123, P0128, P0131, P0132, P0133, P0134, P0135, P0137, P0138, P0140, P0141, P0171.
|
|
On Sat, 29 Aug 2009 08:25:54 -0700, Steve <hgd@wsx.inv
Have a 2003 Highlander. The malfunction indicator lamp went on a
couple days ago, had the code read at an auto shop - P1135. Is this
something to worry about? Any idea what it should cost ...
Started by Steve on
, 22 posts
by 5 people.
Answer Snippets (Read the full thread at omgili):
There is another code for the O2 Sensor Heater (P0135,
http://autorepair.about.com/od/obdcodedatabase_ are being
described by P1135, I'd be telling the firmware to report the P0135 code
that already that defines the same malfunction....
|
