|
Just doing this on my motor, actually going to install Isky EZ roll lifters in place of my std Isky red zones after 2 seasons no failures or anything but have a set on the bench ready to use My question is everyone says check the cam lobe OK is it as ...
Started by CDN SS on
, 14 posts
by 9 people.
Answer Snippets (Read the full thread at chevelles):
I must add, I'm planning on doing a valve spring change and having the Iskys rebuilt later this winter measurement told me the #4 exhaust lifter had a variance !! My lifters have a floating pushrod seat and once wheels are....
|
|
My Ody has a tappet knock.
Like an idiot I believed the service advisor at the local dealership who said the vavle train on the Ody has hydraullic lifters. (this was during the warranty period).
Since I never looked at a breakdown of the engine or any...
Started by pvandegriff on
, 2 posts
by 2 people.
Answer Snippets (Read the full thread at odyclub):
10-05-2003, 02:25 AM #3 Sandstone May 2003 Location Las Vegas Posts 37 Having reviewed the valve adjustment procedure....
There is a summary of the procedure HERE
The maintenance schedule calls for "adjust only if noisy when noisy".
|
|
My Ody has a tappet knock.
Like an idiot I believed the service advisor at the local dealership who said the vavle train on the Ody has hydraullic lifters. (this was during the warranty period).
Since I never looked at a breakdown of the engine or any...
Started by pvandegriff on
, 2 posts
by 2 people.
Answer Snippets (Read the full thread at odyclub):
10-05-2003, 02:25 AM #3 Sandstone May 2003 Location Las Vegas Posts 37 Having reviewed the valve adjustment procedure....
There is a summary of the procedure HERE
The maintenance schedule calls for "adjust only if noisy when noisy".
|
Ask your Facebook Friends
|
My Ody has a tappet knock.
Like an idiot I believed the service advisor at the local dealership who said the vavle train on the Ody has hydraullic lifters. (this was during the warranty period).
Since I never looked at a breakdown of the engine or any...
Started by pvandegriff on
, 2 posts
by 2 people.
Answer Snippets (Read the full thread at odyclub):
10-05-....
I only when noisy".
There is a summary of the procedure HERE
The maintenance schedule calls for "adjust only if noisy Location SoCal - The OC Posts 501 Just took my Ody to the dealer for an oil change today.
|
|
So my sis's 95 850 turbo has had a re-occuring missfire code on cyl#3. She said it was running odd, low on power then cold, so i did a much needed tune up (plugs wires cap rotor fuel air) used all OEM stuff and bogi wires, code came back. I cleared it...
Started by volvorod85 on
, 22 posts
by 8 people.
Answer Snippets (Read the full thread at turbobricks):
I've worked that....
And it idles way too well to be a valve issue
But the lifter noise, yes! I have checked the oil to make lifters, but could the heavy oil be pumping up the lifters/holding a valve open?).
|
|
On Thu, 08 Jan 2009 17:37:12 GMT, Stealth Pilot <notransponder@aeroplanes.com.au
veedubber and others
the venerable old VW engine conversion is quite usable.
if you were to take all the lessons learnt from all the engine
building done so far and...
Started by Stealth Pilot on
, 80 posts
by 17 people.
Answer Snippets (Read the full thread at omgili):
The next would be valve seats (hydraulic lifters won't help from the vintage car meets is that the
sleeve-valve Willies-Knight, is that even in good running starting point?
Oil....
That don't
go all the way across).
|
|
Found this on the net and did some formatting to the text to make it easier to read :
BMW 5-Series E39 (1996 - 2003)
Quote: Overall Rating 4/5 :
Good: Some great engines. Good ride and handling. Classy looks. Performed well in JD Power Customer Satisfaction...
Answer Snippets (Read the full thread at bmw5):
# BMW variable cam shaft timing (oil seals) to DISA intake butterfly valve, all probably guessing wrongly malfunction to worn....
Tapping hydraulic cam valve lifters heard from the side (oil pressure or viscosity problem).
|
|
Greetings,
I purchased my 2008 Explorer Ltd about 6 months ago with a 4.6L and 63k miles. I use it for towing a small travel trailer, so I don't put many miles on it. It's got about 67k on it now. According to OASIS, it has had all MFR maintenance performed...
Started by pjw73nh on
, 20 posts
by 6 people.
Answer Snippets (Read the full thread at explorerforum):
Emission Control
System
• Exhaust Gas Recirculation
(EGR) System
• Exhaust Heat Control Valve
• Exhaust Pressure Control
Valve (1)
• High Voltage Battery (HEV)
• Idle Air Bypass Valve
• Ignition Coil Lamp
(MIL)/On-Board Diagnostic....
Related shopping results:
|
|
Reliability question for Raptor... Have you had much (any) feedback from buick and ecotec owners running the Raptor after a while?
Such as broken engine parts. I mean, logically, force induction on stock engines/parts is only gonna last for so long due...
Started by totq on
, 25 posts
by 10 people.
Answer Snippets (Read the full thread at justcommodores):
224 232 @590" Vcm Suite Cam, Crow Cam Valve Springs, Aftermarket Lifters, Ls1 Double row, i dont know what oil you use or how ofter you change but that factors as well on a boosted motor the bearings are about....
And intercooled.
|
|
On Thu, 7 May 2009 10:09:09 -0400, "jimz" <jss@tricomachine.com
Would you buy a a car from an American car maker
right now.
Starting with me -
no
Started by jimz on
, 165 posts
by 48 people.
Answer Snippets (Read the full thread at omgili):
But, I only ....
I can hesitation.
It's a rare American car with 50K or more miles where the
lifters DON'T clack.
2009 12:28:56 -0700, SMS <scharf.steven@geemail.com
There's a lot of focus on the oil change
Ummmm...
|
