|
[Admin warning: structural heat (or thermal) treatment of a home is not a do it yourself project. People who have tried to do their own heat treatments for bed bugs have discovered they made the problem worse, and spread the bugs. Some have even burned...
Started by heattreatmentlandlord on
, 34 posts
by 15 people.
Answer Snippets (Read the full thread at bedbugger):
The heat rising from the lower unit not migrate to adjacents units?
How does heat affect existing chemicals applied?
Hypothetically a serious fire hazard, if they are utilized....
The walls, which would then in turn bake the wall voids.
|
|
Hi,
I have Stilo 1.4 aircon active on an 04 plate.
Some time ago my radiator sprung a leak and I lost all the water. It was in the middle of our coldest winter last year. I was out of work at the time and could not afford a new rad. So I Put a sealant...
Started by battygb on
, 5 posts
by 2 people.
Answer Snippets (Read the full thread at fiatforum):
Haven't taken it for a drive yet so don't know if it will continue.
Of the vents is stronger and hot.
|
|
When I turn the heat on in my car, the windows fog up...? Is this normal? It's weird because condensation builds up a lot on the inside of the windshield. Any ideas what could be wrong?
Started by Katy on
, 6 posts
by 6 people.
Answer Snippets (Read the full thread at yahoo):
Hot engine coolant flows....
The heater core is basically a small reverse radiator.
With the heat on for 15 minutes or so for the coolant to flow through the heater core, then let it coolyou've got a pinhole in your heater core.
|
Ask your Facebook Friends
|
Hello, I have a 1998 Buick LeSabre Limited. I recently replaced the water pump, flushed the radiator, replaced the thermostat, and bled the radiator for air lock. Now, when I turn on the heater I get mediocre heat only on the drivers side and freezing...
Started by Pedantic.2012 on
, 13 posts
by 4 people.
Answer Snippets (Read the full thread at automotiveforums):
As for the heat temp on either side direction ....
On the heater I get mediocre heat only on the drivers side and freezing cold air through the passenger side and will next compare the heater hose temperatures between the two.
|
|
Heaters blowing cold..
Ok guys, iam after a bit of advice here because iam quite baffled with this. On my way to work this morning the heaters gradually cooled down until they were just blowing cold air out, having been fine before hand. The temp gauge...
Started by Black Bullet on
, 12 posts
by 5 people.
Answer Snippets (Read the full thread at mg-rover):
Its called heater bypass valve in it ? my know how of the zr ends there im afraid on plumbing !! so is because my heaters did that and it turned out to be a heater bypass valve that had failed but i think system as always ....
|
|
I'm planning on setting up a 55 gallon drum with some drains exc. as a settling tank for wvo. Right now the temp at night is about freezing. My question is if I wanted to settle a tank to avoid major filtering, would installing a small heater, enough ...
Started by duotottman on
, 13 posts
by 6 people.
Answer Snippets (Read the full thread at infopop):
My barrels have two water heater elements, this produces 250 watts from each element....
Use 'heat trace' cable evenly wrapped around the barrel and completely covered the realy tiny particals to settle unless you wait months.
From settling.
|
|
I have one from about 3-4 years ago and it keps sticking on. It is a 200 watt heater and i have it set to 78 but My QT tank temp goes all the way up to 82 with it and it is still on so I have to turn it off.
I cant remember if this can be calibrated. ...
Started by krzyphsygy on
, 15 posts
by 5 people.
Answer Snippets (Read the full thread at reefcentral):
Let sit for a couple hrs plugged in and see if the heater can set the temp you want the heater to heat up to and it should get it there fairly close can set the temp you want the heater....
turn the dial till it just go's off.
|
|
I installed a glow plug intake heater on our 5000 and instead of using a reservoir box to hold the fuel, I put a T in the return line near the top of the tank and ran a line to the heater.
I bought a new 5-wire switch to put on it, but decided against...
Started by snowcrash on
, 13 posts
by 7 people.
Answer Snippets (Read the full thread at ytmag):
Fuel-fired heaters like these 4-5000 units use need longer....
It
warms a heat-activated valve enough to allow fuel
into/onto the element, which ignites the fuel manuals all say to use the heater 30 to 90 seconds before trying to start.
|
|
Figured I would start a seperate thread on this subject.
Quote: : Post #28, Fuel Filter Query Thread
It is a *home made unit*.
I have not found any electrically operated units that are commercially made.
The switches *up front* energise relays for maximum...
Started by ByrdMan on
, 15 posts
by 6 people.
Answer Snippets (Read the full thread at ppcflyingforums):
One line voltage thermostat can (The heat is largely concentrated in the tip, but whatever ...) then it may be plenty of heat to just all about heat, ....
Because heat tape thermostats sometimes turn on as high as 50?.
|
|
Posted 07 February 2012 - 04:54 PM
I mentioned this in my ice hut build thread, but I think it's worth repeating.
I spent the night in my shack using a propane heater because the wood stove isn't installed yet. The day I was going there I was a Lowe's...
Started by fishNwire on
, 11 posts
by 9 people.
Answer Snippets (Read the full thread at ontariofishingcommunity):
The coleman heater that almost killed me and some friends and a heater with carbon monoxide shut off and just in case a carbon monoxide detector , better safe and was going to use it to ....
Or in the instructions and warning documents.
|
