|
Changed to a dog house style shroud and cooler and just wanted to make sure it was ok to run and external cooler with it??? Car came with an external ..
Started by D Buggy on
, 20 posts
by 11 people.
Answer Snippets (Read the full thread at thesamba):
Also, when you install your doghouse shroud/cooler set up, make sure you use the factory thermostat ratios and a good tune will ensure proper....
You can but have you determined that you need an external cooler? It is possible to over cool your.
|
|
Cooler Master Hyper 212 evo cooler fan speed problem guys i bought this cooler and installed it in to my comp.the fan speed reaches 1800 RPM at full load and decreases to 1600RPM at idle but actually it should reduce its fan speed to 600 at idle.i have...
Answer Snippets (Read the full thread at thinkdigit):
Re: Cooler Master Hyper 212 evo cooler fan speed problem you have installed the fan on 3 pin or 4://topgeartopspeed.wordpress.com/ Re: Cooler Master Hyper 212 evo cooler fan speed problem
u must have connected the fan|| Zebronics....
|
|
The coolers were a success with nvidia cards, cooler mater is hoping to make an evolution to the cpu cooler market rather then an improovement
http://www.hardwarecanuck...r-chambers-technology/
^ 69.99 comformed priced
update : it is two champers , each...
Started by warlord420 on
, 12 posts
by 12 people.
Answer Snippets (Read the full thread at evga):
That's how I equate this cooler in my mind or infantile to be used as in the ....
Many early jet engines weren't used as primary propulsion devices for large aircraft to power large aircraft on their own, just small ones .
Choice air cooler.
|
Ask your Facebook Friends
|
Well had to change out the rad in my zj
started it up to change the oil
and it was leaking pretty bad
pressure test confirmed (showed me) it was leaking above the drain
anyways
in looking threw the FSM and removing the old rad
i have 2 tranny lines coming...
Started by ryan86jeep on
, 12 posts
by 6 people.
Answer Snippets (Read the full thread at jeepsunlimited):
Explorers seem to, a 91 had it and our Sport 2002 coolers, or at least ZJ's....
You'd think all Jeeps would have them.
Look into the cooling chapter of your oil cooler.
That the tranny cooler would be the 1st option between the two.
|
|
A friend of mine has an 05, he bought the truck and put less then 1k miles on the truck.
He bought it and got a reciept for new oil cooler and bullet proof egr cooelr from sinister the company in R.I. did the work about 1k miles before he bought it. So...
Started by 2006powerstroke90 on
, 15 posts
by 7 people.
Answer Snippets (Read the full thread at ford-trucks):
I would definitely....
My guess would be a faulty EGR cooler given the low miles since the install and the sinister cooler isn't supposed to fail.
Was it a EGR deleate or just upgraded cooler Hard to know without knowing the ECT/EOT spread.
|
|
#08-07-30-049: Transmission Oil Cooler Line Leak (Replace Affected Cooler Line) - (De Subject: Transmission Oil Cooler Line Leak (Replace Affected Cooler Line)
Models: 2006-2007 Chevrolet Silverado Classic 2500/3500 Series
2007-2009 Chevrolet Silverado...
Started by tracker954x4 on
, 15 posts
by 2 people.
Answer Snippets (Read the full thread at thetruckstop):
It's been a while since I felt so dumb and wish I had a digital camera so .
Once you get of the turbo cooler circuit.
Both cooler lines to the side of the engine, its a bit of a PITA sometimes to get undone.
|
|
I bought a new mobo with Socket 1156 (Asus P7P55D PRO). Previously I had a mobo with Socket 775 and CPU cooler AC Freezer 7 Pro. However, I'm not able to fit the cooler to the new mobo eventhough the mounting holes look to be at the same positions. I'...
Started by Elephantik on
, 3 posts
by 3 people.
Answer Snippets (Read the full thread at superuser):
I remember that I also....
What problem do you face when trying to fit the cooler?
You say the mounting holes are in the correct position, so what is stopping it from fitting?
According to Newegg your cooler should support i7 cooler).
|
|
Heres what I did to reduce a substantial amount of heat from my transmission and engine oil take II. (the first one had a few hickies) cooler mod.pdf You do not have the required permissions to view the files attached to this post. Last edited by atcer...
Started by atcer1 on
, 11 posts
by 3 people.
Answer Snippets (Read the full thread at lesharorv):
Http://f1.grp.yahoofs.com determine which way the trans oil flowed, and is the new cooler flow directional sensitive?
Rick Rick.
The temperature at the oil filter cooler, the hose arrangement thing.
|
|
Hi everyone, I'm looking for a LGA1155 air CPU cooler. I've set my eyes upon CM GeminII S524, which seems good considering it can cool the MB too. I'd like to know your opinions and feel free to give suggestions(preferably CM's since it's easily available...
Started by NiMx1233 on
, 12 posts
by 5 people.
Answer Snippets (Read the full thread at overclockersclub):
Also can you link a site/s that you can purchase from? If not then the Gemini looks to be your cooler can you link a site/s that you can purchase from? If not then the Gemini looks to be your cooler
It's the best cooler I've ever....
|
|
I have this installed on my 2500k and at idle with no OC I run about 32C. I swear that is what it ran on my stock cooler also or at least pretty close. My case is a HAF 912 with a 200mm side fan installed.
I pulled it yet again today and found I put way...
Started by compunoob on
, 19 posts
by 9 people.
Answer Snippets (Read the full thread at rage3d):
At default clocks that sounds about right i think The V8 isn't... .
I let the cpu down clock at idle.
All its running a little cooler than I thought.
What the CPU looked like when I pulled the sink
What the cooler base looked like.
Some pics.
|
