|
408 hke boost engine complete 1000hp fuel system
I've been slowly taking my truck apart and here are the next items up for graps. All these parts are pretty much new and motor has less then 800 miles on it. I'll either sell it as a whole long block with...
Started by vicalma03 on
, 5 posts
by 5 people.
Answer Snippets (Read the full thread at houstonperformancetrucks):
Damn i hope you still got it in 2 week... .
You currently have 0 posts.
Damn I wish the throttle body was a 102mm
To view links or images in signatures your post count must be 10 or greater .
Btw your truck is sick Im allergic Aaachoooo! to hatters .
Glws man.
|
|
My fuel pressure has been acting funny latey it will start losing pressure after driving for about a hour and start getting slower and then if i turn it off and try starting again it will be at like 10psi and car will barley run of not even start but ...
Started by dean-93 on
, 6 posts
by 3 people.
Answer Snippets (Read the full thread at corral):
Kinda low probability though..
Could poss be 1 of those..
|
|
Were to buy
im currently lookin for a fuel pump nd iv heard is best to get walbro 255 were wat store can i pick em up
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
Started by LA FIVE 3 SPECIAL on
, 8 posts
by 5 people.
Answer Snippets (Read the full thread at houstonperformancetrucks):
Bought a tre performance version from tre performance on ebay for....
Walbros may be popular but the only ive had went bad quick .
Highly recommend the tre performance 255 fuel pumps..
No complaints.
|
Ask your Facebook Friends
|
Hey guys!
This is my first post here and im looking forward to adding to my knowledge.
My project car is a 2001 Ford Crown Victoria. I've had it for a year now and I'm doing a lot of work to it. So as I get things done I'll add more here.
So far I have...
Started by NGreen0807 on
, 11 posts
by 5 people.
Answer Snippets (Read the full thread at corral):
It's been done before in the panther....
I have a Ram HDX clutch, Steeda Tri-Ax, Spec billet steel flywheel among other things .
The 4R70W is blown right now and I need it back on the road .
Stick in a crown vic, pics when its in please Oh it'll be in shortly .
|
|
GSX SEX! lol Hi i'm kevin, i live in Laredo,Texas I started this built 3 months ago on my 95 GSX and this is my built thread, i did all the work myself.
Engine bottom end
-Eagle rods
-Wiseco 8.3:1 pistons
-oem balance crank
-clevitte main and rod bearings...
Started by kidtsi on
, 25 posts
by 8 people.
Answer Snippets (Read the full thread at htown-dsm):
(thanks jake)
AEM black camgears
HKS 272s
ARP camgear bolts.
SS pressure plate
STage 3 TRE tranny.
|
|
Hello dear friends,
since I have the idea to join you on the EU-meeting in september, I have to be sure to cover the distance from Belgium to Italy ( and back, thank you ;-).
The car is at the moment in good condition but I feel a bit uncertain about ...
Started by dirk van rompae on
, 7 posts
by 4 people.
Answer Snippets (Read the full thread at alfabb):
- SPEC AFR Canton Corbeau RC Walbro 255LPH Fuel Pumps but have not gotten aroundMy Montreal was....
However, the fuel flow from this pump is less than from the 2 stock pumps, and can Performance Inc.
In the 1980s.
|
|
I am looking to trade my 2003 Evolution VIII for a 2005 STI (will not consider a 2004). The car is very clean inside and out. It has been professionally maintained. No leaks, ticks, or burning of any sort. This car is my daily driver and has never given...
Started by b00stedsuby on
, 19 posts
by 9 people.
Answer Snippets (Read the full thread at nasioc):
Not far at all consider a trade?
http://forums.nasioc.com/forums/show....php?t=2245266 bump for a fellow michiganer and a fellow xceeder too? good deal... .
Minus the wheels of course Located in Viva Las Vegas.. .
If you were closer I would consider trading...
|
|
Dyno'd the 03' z1000 yesterday. Some interesting results about TFI/PC3 Well.. I dyno'd both the z1000 and zx10r yesterday with good results for the both of them.
Performance Modifications on the 03' Z1000 are: Full Muzzy System, K&N filter, Airbox lid...
Started by GOODRODE on
, 15 posts
by 10 people.
Answer Snippets (Read the full thread at RiderForums):
Fiber LOR can, PC3 with custom map, Integrated Smoked Turnsignals, BMC Race Filter, TRE, Moose, TRE, Moose Handlebar, Targa Seat Cowl, Race Intake Cam, Degreed Cams 107/104
2009 ZX-10r
2Bros, Integrated Smoked Turnsignals, BMC Race Filter....
|
|
$3500 for the '96 Talon.
$3000 for the '98 Talon with the extra 2.4
$6000 for all of it.
Cash or Paypal only (some type of instant payment, in other words). I won't mess around. If you're serious, be serious and we'll talk.
'96 Talon TSi AWD 5-speed (...
Started by alltrbo on
, 20 posts
by 6 people.
Answer Snippets (Read the full thread at realfierotech):
Otherwise, you could paint it cheap, strip it out, and turn it into a sweet lightweight AWD racecar... .
With a professional quality prep and paint it could look this good again or better .
I have tons of pics of the '96 in its prime, here a few of my favorites .
|
|
OMG... my last post took to long to "post" and got kicked out.
Now this post will be shorter.
I will try to answer all questions HERE, I do not do PM's. Nothing to hide.
3.0 motor, opened intake heads, electromotive twin plug, crank fire, 46mm weber carbs...
Started by guinness75 on
, 20 posts
by 10 people.
Answer Snippets (Read the full thread at pelicanparts):
Sport (puck) clutch, alum pressure plate....
It was listed at TRE.
It sat around for years.
He used it only one track day @ willow springs .
And any thing.
Mods, type of rods head studs, oil pump , cylinders (nickies?) springs and retainers.
|
