|
Betacom 24 he, two years old, no sign of distress, but intermittent early shut down on heating and hot water, water pressure ok, condensate ok, gas pressure and rate ok, any suggestions?
Started by Micky T on
, 5 posts
by 2 people.
Answer Snippets (Read the full thread at ukplumbersforums):
Thanks.
Does it go to lockout or does it start up again on it's own? Goes to lockout Sounds PCB related, perhaps check the connections and flame sensor positioning .
|
|
Need buying advice on Direct Vent gas FP
We are getting ready to build and are trying to decide which fireplace to go with. I received a Quote: for Kozy Heat Minnetonka and Fireplace Xtrordinair 864 HH from 2 different places. There is also a Heat n ...
Started by buildingsoon on
, 4 posts
by 4 people.
Answer Snippets (Read the full thread at hvac-talk):
I have been putting.
Never had experience with Kozy but Heat & Glo is a good product.
|
|
Well my foster Satoh 670D doesn't have a visible label for any settings for glo-plug etc. There looks to be a label on the right with a rotary switch but it's all faded.
It was cold, 25 deg F, and it wouldn't fire, and I can't get ahold of my cousin-in...
Started by newbury on
, 10 posts
by 5 people.
Answer Snippets (Read the full thread at tractorbynet):
If needed I use to wet a rag with Gas and lay it over the air inlet to give-heat the glow plugs, the....
Caterpillar is different.
Then try again for 10.
For 60 seconds so the fuel in the cylinder, can absorb the heat from compression.
|
Ask your Facebook Friends
|
I received at Christmas the Dyna-Glo Convection Heater from Home Depot . I have been using it in my six hundred square foot garage and I find it very effective. I am thinking about stripping, staining and polyeurathaning a piece of furniture and I am ...
Started by aumanpj on
, 10 posts
by 9 people.
Answer Snippets (Read the full thread at diychatroom):
Pre-heat the space killed us, the oil/gas being....
He died 6 hours later....
Drop explosion caused by fumes while working on a wood floor .
Ive done the pre -heat and turn the heater off thing, but your probably gonna get a fast temp.
|
|
I'm replacing my water heater and wondered if anyone here has had experience with a tankless one.
I'm a little concerned about going with one because they are rather new and unknown-also rather expensive. Additionally, have been told by a couple of 'experts...
Started by gloria on
, 9 posts
by 6 people.
Answer Snippets (Read the full thread at mobtalk):
The yearly operating ....
Shorty,
I have some radiant heat in my master expenditures.
Plumbing ( http://www.mannplumbinginc.com/plumbing.html .) I have radiant floor heat in my house workers and willing to talk without a hard-sell attitude.
|
|
Well, With all of this springer talk, I decided to go fish for a few hours off sauvies island at the staircase. All I caught was a bunch of ,<edit>from some boaters. I was fishing 65yds out. I guess the problem was that I was using my kayak to drop...
Started by Austin on
, 60 posts
by 43 people.
Answer Snippets (Read the full thread at ifish):
A spin-n-glo that's what I would have done, but 10 wouldn't hold two k15's.
|
|
Hello
Unfortunately not everyone knows!! This house is in the San Fransico Bay Area.
Fire started at 4 AM.
Luckily the family of 5 on Walnut St all got out safely because they recently replaced the battteries in their smoke detectors! The house is a total...
Answer Snippets (Read the full thread at hearth):
Those warnings and clearances in the manuals combustibles near a piece of appliance... .
His ski jacket in front of the glass produces a lot of radiant heat.
I stayed at a Holiday Inn a customer got too close to the glass of the Heat N Glo.
|
|
Hello evrybody! New guy here from TN. I have a pre-fab fireplace, Heatilator Model HD36B, & I am wanting to replace it with a wood burning insert or a wood stove. I am thinking it is too small to use an insert & I will probably have to use a wood burning...
Answer Snippets (Read the full thread at hearth):
It might use the same venting as your Heatilator boxSomeone’s gonna ask…
Is this intended to be a primary heat source? If not, how much?
Do you have access to fuel?
What fuel sources are....
Might think about the Heat n Glo Northstar.
|
|
Thank You Fred Upton (R): Light Bulbs to Cost $50 Each
5/16/11
Two leading makers of lighting products are showcasing LED bulbs that are bright enough to replace energy-guzzling 100-watt light bulbs set to disappear from stores in January.
Their demonstrations...
Started by American_Jihad on
, 5 posts
by 2 people.
Answer Snippets (Read the full thread at xerces):
Gelobter: We can have a pollution charge on greenhouse gas pollution, or we can auction the right to emit greenhouse gas....
You can see theres an impact on agricultural, and more money .
Louis.
See it in the disparity in heat deaths in St.
|
|
On 18 Apr, 01:41, M-M <nospam....@ny.more
What you were taught in school is more or less correct about why a
flame is yellow. The yellow flame is either due to tiny carbon
particles heated to incandescent temperatures or due to tiny amounts
of sodium...
Started by bm459@scn.org on
, 8 posts
by 3 people.
Answer Snippets (Read the full thread at omgili):
A standard glo plug ....
It will not harm engine life a bit.
On a side note, I found a store selling 4 packs of Heet gas line?
The simple fact is ethanol is a perfectly good fuel in glo engines.
Of
methanol for comparison though.
|
