Omgili - forum search, search forums  
  

Discussions about hub rant rear

Displaying 1 - 10 out of 181 discussions.  
RSS Feed Options
Time Frame: (Any time)   Minimum number of replies: (2)   Minimum number of discussing users: (0)
  |  

Page: 1   2   3   4   5   6   7   8   9   10  
Keep this page open to be updated with the newest discussions automatically.
Hello, I recently bought a 99 ford ranger "off road". It has a 4.0 V6, which is a nice engine to have for the size of the truck. 5 speed manual tranny and 4x4. Truck has 135k on it. After I bought it I replaced the clutch, slave and throughout bearing...
Started by on , 15 posts by 7 people.  
Open rear end does not equal "junk" rear end for Rangers.
-- sorry just had to rant.
About right.
It's February 2012 there hasn't been 1 new diecast car anywhere in my area since November 2011! What gives? Is Mattel going under? Did I tick someone off with all my crazy videos? What? OK! So fine I decide to take up another hobby, building bicycles!...
Started by on , 4 posts by 4 people.  
You....
Johnathan! How can you live in southern California, and fail at locating custom bike parts? It's a theoretical impossibility! I found a place for ya, it sounds like what you're looking for!.. .
Dude you stopped taking your meds again, didn't you Mr .
I am new to the forums and have scoured them for knowledge on this problem. I have a 2002 avant and the rear wiper motor is knackered (spindle leaking into the motor) a simple fix if only I could get the arm off. I have patiently applied penetrating oil...
Started by on , 15 posts by 7 people.  
Hehe 2, purchase wiper arm puller apparently its a bit like the disc/hub puller and do it that way see dealerships I paid 83 just do without it?? mine went on me so i went for the smooth rear screen look..
Related Videos:
Ask your Facebook Friends
Hi all, Not enjoying this rear and rebuild on the sci one bit. Today I thought I would be finished where as I have not even finished the one side yet. So far I have had both rear shock bolts (bottom) shear as well as access to the top bolts being only...
Started by on , 4 posts by 4 people.  
For the rear springs, I use a proper brake.
Remove the rear hub, it makes it whole lot easier!!!! Ming I cut groves in an old screwdriver (picsFluffy at eurocarecare will have one on the shelf.
Using a real rough estimate, it looks like a 330rpm increase per half a gear ratio increase at highway speed. 2.65 = 2000 3.06 = 2330 3.50 = 2660 3.92 = 3000 Again, these are very rough estimates. There is a formula to calculate the rpm but I don't know...
Started by on , 11 posts by 9 people.  
Gear spacing seems kinda like they pulled ratios.
The craptastic transmission (NAG1) more than the rear gears...
Dave's Transformers Animated Rant: Deluxe Wave 6 Waspinator (techno-organic wasp) Samurai Prowl (remold, new accessory) Permalink: http://www.eyrie.org/~dvandom/BW/TFA/Deluxe6 I ordered these from HasbroToyShop.com too, although...
Started by on , 3 posts by 2 people.  
Answer Snippets (Read the full thread at omgili):
In article ....
Not sure if that's what you were aiming to say .
On Tue, 31 Mar 2009 22:44:06 -0400, Sidecutter <sidecutter_spamsucks_@insightbb.com Just a note on Prowl's remolds, but his entire thigh sections are all new now, not just the pads .
Dave's Transformers Universe Rant Swerve (Chevy Aveo) Permalink: http://www.eyrie.org/~dvandom/BW/Universe/Swerve http://tfwiki.net/wiki/Swerve_%28Chevy%29 describes the strange history of this toy. During the initial "release" I didn...
Started by on , 4 posts by 4 people.  
Answer Snippets (Read the full thread at omgili):
I really need to get my basement shelves finished....
I did spend the money to import one from Singapore or somesuch when it first came out, and I don't regret it .
On Tue, 11 Aug 2009 18:35:23 -0600, Shin Hibiki <shin_hibiki@hotmail.com Good score .
Dave's Universe Classics Rant: Deluxe Wave 6 Ratchet (Ironhide remold, redeco) Hot Shot with Jolt (Sportscar and mini-helicopter) Permalink: http://www.eyrie.org/~dvandom/BW/U2/Deluxe6 It looks like this wave is getting hosed by...
Started by on , 4 posts by 3 people.  
Answer Snippets (Read the full thread at omgili):
At ....
On Sun, 5 Apr 2009 21:52:46 -0700 (PDT), Gustavo Wombat <GustavoWombat@yahoo.com Is this actually the same lightbar, or just a very similar one? It would be really nifty if they were designing these toys with that much interchangeability .
Dave's Revenge of the Fallen Rant: Scout Wave 2 Scalpel (Microscope, 92177) Reverb (Motorcycle, 92178) Dune Runner (Dune Buggy, 92179) Permalink: http://www.eyrie.org/~dvandom/BW/RotF/Scout2 Officially, I think this may be ...
Started by on , 4 posts by 3 people.  
Answer Snippets (Read the full thread at omgili):
On Sat, 18 Jul 2009 15:18:57 -0400, Sidecutter <sidecutter... .
Cordially yours: Autobus Prime w/minicon Farebox.
On Sat, 18 Jul 2009 10:42:05 -0700 (PDT), Autobus Prime <autobus_prime@yahoo.com DVD: I bet it's supposed to say "Cahnay Racing" .
Dave's Human Alliance Rant Wave 1 Bumblebee with Sam Witwicky Permalink: http://www.eyrie.org/~dvandom/BW/RotF/HA1 The Human Alliance line gives us larger vehicles with sorta-to-scale human (or mechanoid) figures that can ride inside...
Started by on , 3 posts by 3 people.  
Answer Snippets (Read the full thread at omgili):
Which is the best justification I can think ....
Now if Sam became Bumblebee's head.
On Sat, 15 Aug 2009 22:26:55 -0400, Ka Faraq Gatri <kfgatri@verizon.net On Sat, 15 Aug 2009 22:10:26 +0000 (UTC), dvandom@eyrie.org (Dave Van Yeah .
Page: 1   2   3   4   5   6   7   8   9   10  

Related Message Boards & Forums

  • A4/A4 cabriolet/S4 (B6 chassis)
  • Cinquecento / Seicento - The FIAT
  • Die Cast Collecting - HobbyTalk
  • Charger Discussion (2nd Gen) - Lx | Dodge Charger Challenger Magnum | SRT8 | Chrysler 300
  • General Discussions - The Ranger Station
Related Searches
shadow rant v2 rear hub review    Shadow Rant V2 Rear Cassette Hub   
More Information


Forum Search About Omgili Help Plugins Forum/Board Owners Privacy

i
In Title
In Topic
In Reply
Exclude
Boost