|
I will be needing to back up about 8-10 computers, and am considering getting a single high capacity ups for the job.
I am assuming somewhere around 3000VA will be needed for this, but the real question is if its safe to power the whole thing from a single...
Started by jcinacio on
, 5 posts
by 5 people.
Answer Snippets (Read the full thread at superuser):
Your new 3KVA UPS and dedicated....
The outlet check the plug before you buy or you may end up with something you can't plug in without an additional cost.
Standard wall plug won't be enough to power the UPS and computers.
Them installed.
|
|
Battery plugs spark when i plug them in is this common? Every thing works fine
Started by muck on
, 12 posts
by 9 people.
Answer Snippets (Read the full thread at traxxas):
Get a 2s and plug it in and power up the system and drive it for about two min.
Or bigger battery.
|
|
Has any 1 put a single plug ecu engine into a 3 plug ecu car if so what needs to be done to make all the dials work thanks
Started by payney on
, 11 posts
by 6 people.
Answer Snippets (Read the full thread at 106owners):
Re: has any 1 put a single plug ecu engine into a 3 plug ecu car As far as I am aware apart of the sensors off the existing 3 plug engine onto the single plug!
Whats not working on your dash? 98 Indigo on the front), Half a....
|
Ask your Facebook Friends
|
DENSO ITV22 Spark Plugs are now in stock. The Denso ITV20 plugs are the same heat range as the factory plugs so why go with a "colder" rated plug?
A higher heat range plug has the ability to stay cooler than a lower heat range plug due to a less insulation...
Started by edgeautosport_JP on
, 14 posts
by 5 people.
Answer Snippets (Read the full thread at smallvolvos):
For all the other Mz3 Owner's Reading this thread...these ....
PM'ed.
Helps with knock also.
|
|
3 plug 2001 independence to 3 plug 2001 vtr, check list? Just found myself a good enough engine to go into my car, but just want to get corrected on what components I will need
I plan to run it on my 1.1 gearbox, but have just read that the clutches arenot...
Started by butchbid on
, 14 posts
by 4 people.
Answer Snippets (Read the full thread at 106owners):
To be honest unlocked ecu is prob easier Re: 3 plug 2001 independence to 3 plug 2001 vtr, check list? Yeah 106lamb Re: 3 plug....
Re: 3 plug 2001 independence to 3 plug 2001 vtr, check list? if your using the ecu that comes.
|
|
I have some parts for sale this is my first time doing this so please be patient with me. Here are the prices or best offer – pictures available.
92-93 Bumper Plugs $40 Shipped (sold)
90-91 Bumper Plugs (7 sets) $20 Shipped. one set (sold)
DOHC Side Fender...
Started by 92gsr91gs on
, 19 posts
by 11 people.
Answer Snippets (Read the full thread at g2ic):
FL:Owners Manuals
93 Owners Manual (Front page a little beat up) $25 Shipped
93 French... .
Whao bumper plugs!
Here's a business plan someone could do,
Take either the 90-91 set or 92-93 set and make molds and replicate more! There is money right there.
|
|
Background: The ATI compact Fatboys and Titans have a problem with the reverse recoil spring plug cracking (inferior design). Many of us owners have converted to using the Colt Defender recoil assembly as the backer plate on the ATI recoil assembly gets...
Started by Hicompression on
, 18 posts
by 4 people.
Answer Snippets (Read the full thread at 1911forum):
Firing with this plug/rod combination.
|
|
I am wanting to service my IS250 SE-L myself. Have purchased ALL original parts. Had the car in the air and removed a small panel (3 10mm screws) Haven't a clue what it reveiled?
Had a good look around while i was there and couldn't for the life of me...
Started by neal on
, 20 posts
by 9 people.
Answer Snippets (Read the full thread at lexusownersclub):
Having....
Find a drain plug MacRS200, on Aug 30 2007, 12:00 AM, said:
Everyone has been very conservative that if you can't find a drain plug neal, on Aug 30 2007, 02:45 AM, said:
MacRS200, on Aug 30 2007, 12:00 AM the buyer you are competent.
|
|
USB is keyed so that it can only be plugged into a port a certain way, to ensure that the contacts touch. But what if you either forced it to plug in improperly, or the port itself was worn down and the plug was worn down and you could plug it in backwards...
Started by GorG on
, 11 posts
by 11 people.
Answer Snippets (Read the full thread at superuser):
The black one is to ground ....
You'll also potentially damage the plug and/or socket so it can't be used.
Are only one one side of the socket/plug so putting the plug in the wrong way round will mean that no connection will be made.
|
|
The instructions simply say to insert the card. When I boot up it says the card has to be plugged in.
It comes with 2 cables and the unit has 2 inputs for a 2x3 plug. Do I plug in both?
I have to say the instructions are horrible, and so is their website...
Answer Snippets (Read the full thread at superuser):
You can plug in both.
Yep, it needs the two 6-pin power-connectors connected to the power supply .
|
